Senco
Senco KC27APBX 34° Clipped Head Framing Nail .131×3 in 2500 pk
34-degree clipped-head framing nails, .131-inch shank by 3 inches long, 2500-count bulk pack for compatible Senco nailers
- TypePower Staplers
- 3 in length drives deep into framing lumber
- .131 in shank provides strong holding power
- 34° collation angle fits Senco and compatible nailers
- Clipped head design allows tighter nail spacing
- 2500-count bulk pack reduces reload frequency
Senco KC27APBX 34° Clipped Head Framing Nails
Senco KC27APBX framing nails are 34-degree clipped-head fasteners supplied in a 2500-piece bulk pack. Each nail measures 3 in overall length with a 0.131 in smooth shank and diamond point. The plain steel finish suits general interior framing where corrosion resistance is not required.
Framing crews using compatible 34° strip nailers
These nails suit framing crews driving 3 in clipped-head nails through a 34-degree strip nailer such as the listed F-35XP, FN91T1, FP325XP, FP701XP or FP751XP. They will not suit users of nailers that accept only full-round heads or a different collation angle. They will not suit applications requiring a coated or galvanised finish for exterior exposure.
34-degree collation angle matches the nailer
The single specification that decides fit is the 34-degree collation angle. Only nailers designed for 34-degree strip collation will feed these clips reliably. Verify your tool’s collation angle before purchase.
Highlights
- 3 in length drives deep into framing lumber
- .131 in shank provides strong holding power
- 34° collation angle fits Senco and compatible nailers
- Clipped head design allows tighter nail spacing
- 2500-count bulk pack reduces reload frequency
Specifications
| Brand | SENCO |
|---|---|
| Type | Power Staplers |
Questions about this item
Which nailers accept the 34-degree tape-collated strips in this 2500-count box?
The strips work with Senco models F-35XP, FN91T1, FP325XP, FP701XP and FP751XP.
How do you load the 34-degree clipped-head nails without jamming the magazine?
Insert the tape strip so the clipped heads follow the 34-degree angle of the magazine rail, then close the latch before connecting air.
When do the .131-inch smooth-shank nails need to be replaced on a job site?
Replace the coil when the magazine runs empty; the 2500-count pack is a single bulk box with no partial refills.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
