Senco
Senco EA0297 Phillips Bit 2 Pieces 1/4" Shank
Two Phillips #2 power bits with 1/4" hex shanks made from S2 steel for auto-feed screw systems
- Phillips #2 tip drives common fasteners
- Two-piece pack provides a ready spare
- 1/4" hex shank fits standard drill chucks
- S2 steel construction resists wear
- 6 3/4" overall length reaches deep recesses
Senco EA0297 Phillips Bit Set
This two-piece set supplies #2 Phillips power bits with a 1/4-inch hex shank. They are made from S2 steel and measure 6 3/4 inches overall. The bits are designed for use with integrated auto-feed screw systems. They are not impact rated.
Check Your Auto-Feed System Compatibility
Verify that your screw-driving system accepts 1/4-inch hex shank power bits. Confirm the tool requires a #2 Phillips tip and a single-ended bit of this length. Ensure the application does not demand impact-rated accessories.
Replaces Worn Standard Phillips Bits
Swap out dull or damaged #2 Phillips bits that no longer grip screw heads cleanly. The upgrade is worthwhile when driving large volumes of screws through an auto-feed system. It is not suited for impact drivers or general-purpose drill chucks.
Highlights
- Phillips #2 tip drives common fasteners
- Two-piece pack provides a ready spare
- 1/4" hex shank fits standard drill chucks
- S2 steel construction resists wear
- 6 3/4" overall length reaches deep recesses
Specifications
| Brand | SENCO |
|---|
Questions about this item
What comes in the Senco EA0297 pack and do I need to buy anything else to use them?
The pack contains two Phillips #2 power bits with 1/4 in hex shanks made from S2 steel, 6 3/4 in long, single-ended and unfinished. They fit directly into a compatible auto-feed screw system or any 1/4 in hex bit holder, so no extra parts are required unless your driver uses a different shank size.
The listing shows only one version; how do I know this is the right Phillips bit for my job?
This model is a #2 Phillips tip on a 1/4 in hex shank, 6 3/4 in overall length, S2 steel, non-impact-rated, designed for integrated auto-feed screw systems. If your application matches that tip size, shank, length and material, this two-piece pack is the correct choice.
What does the 6 3/4 in overall length mean when I put the bit in my auto-feed screw system?
The 6 3/4 in length gives extended reach for deep or recessed fasteners while the 1/4 in hex shank seats securely in the system's bit holder. The S2 steel tip resists wear during repetitive driving, and because the bit is not impact-rated it is intended for standard rotary driving only.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
