We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red pneumatic flooring stapler with top exhaust and magazine

Senco

Senco 16 ga Air Flooring Stapler SHF200

SKU CH-CQ87-738PT

Air-powered 16-gauge flooring stapler firing 1-1/2 to 2-inch cleats at 90-110 psi with 107-nail capacity

  • TypeOffice Equipment & Supplies
  • Drives 16-gauge cleats from 1-1/2 to 2 inches
  • Holds 107 fasteners for fewer reloads
  • Operates at 90 to 110 psi air pressure
  • Consumes 2.5 scfm for efficient compressor use
  • Sequential firing mode for controlled placement

What it is

The Senco SHF200 is an air-powered flooring stapler that drives 16-gauge cleats from 1 1/2 in to 2 in. It holds up to 107 fasteners in a strip magazine and fires sequentially for controlled placement on hardwood or engineered floors. Professional installers and serious DIYers use it for tongue-and-groove applications where a nail gun would split the board.

Installation and common issues

Connect the tool to a 1/4 in NPT air inlet with a hose of at least 1/4 in internal diameter. Supply 90 to 110 psi at 2.5 scfm; pressure below 90 psi causes misfires and pressure above 110 psi risks seal damage. The top exhaust directs air away from the workpiece, but oil the driver blade daily or the sequential trigger will stick.

Practical limits of pneumatic power

The 110 psi ceiling caps driving force, so dense exotic hardwoods may need pre-drilling despite the tool’s rating. A 107-nail magazine means frequent reloads on large rooms, and the fixed 0-degree collation angle limits access in tight corners. Sequential firing slows output compared with bump-fire tools, trading speed for precision on expensive flooring.

Highlights

  • Drives 16-gauge cleats from 1-1/2 to 2 inches
  • Holds 107 fasteners for fewer reloads
  • Operates at 90 to 110 psi air pressure
  • Consumes 2.5 scfm for efficient compressor use
  • Sequential firing mode for controlled placement

Specifications

BrandSenco
TypeOffice Equipment & Supplies

Questions about this item

How can I confirm the SHF200 is firing correctly after connecting the air supply?

Set the regulator between 90 and 110 psi, ensure the hose is at least 1/4 in, then fire a test staple into scrap flooring; the tool should drive each 16 ga cleat flush at the 2.5 scfm consumption rate.

What comes with the stapler and what must I supply?

The SHF200 includes the air flooring stapler body only; you must provide a 1/4 in NPT air hose, a compressor delivering 90 to 110 psi at 2.5 scfm, and 16 ga glue-collated cleats 1 1/2 in to 2 in long.

Which staple length should I choose for 3/4 in solid hardwood?

Use 2 in cleats for 3/4 in solid hardwood; the SHF200 accepts 16 ga glue-collated strips from 1 1/2 in up to 2 in, and the longer leg provides the holding power required for that thickness.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.