We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Compact plastic dispenser holding rolls of coloured polyester wire marker tape in ten colours

Scotchcode STD-C Wire Marker Tape w/Dispenser, Preprint

SKU CH-XS58-74MTB

Pre-printed polyester wire marker tape in ten colours with a built-in dispenser, covering 6/0 to 24 AWG and rated from -40 °F to 250 °F

  • TypeWith Tape
  • ColorBlack, Blue, Brown, Green, Gray, Orange, Red, Violet, White,
  • Pre-printed legends speed up wire identification
  • Ten colour options simplify circuit tracing
  • Acrylic adhesive holds from -40 °F to 250 °F
  • Polyester film resists abrasion and chemicals
  • Fits wire sizes from 6/0 to 24 AWG

Wire marker tape for electrical identification

Scotchcode STD-C supplies pre-printed polyester film labels in ten colours for marking wires from 6/0 to 24 AWG. The self-adhesive acrylic backing sticks to insulation without a separate applicator. Each roll delivers a single legend on a 0.22 in wide tape that is 0.003 in thick. Technicians and electricians use it to trace circuits quickly during installation or maintenance.

Temperature resistance and handling

The tape operates from -40 to 250 degrees Fahrenheit, so it survives cold outdoor runs and hot equipment rooms. Polyester film resists moisture, oil and abrasion while the acrylic adhesive holds without bleeding. The dispenser feeds tape cleanly, reducing waste and keeping the work area tidy. No power or heat tool is required for application.

Build integration and workflow

The compact dispenser fits in a tool pouch or on a belt clip, leaving bench space free for other gear. Labels adhere directly to existing insulation, so no sleeves or heat-shrink tubing are needed. Colour coding follows common industry conventions, helping teams identify phases, neutrals and grounds at a glance. The system works with solid and stranded conductors across the stated gauge range.

Highlights

  • Pre-printed legends speed up wire identification
  • Ten colour options simplify circuit tracing
  • Acrylic adhesive holds from -40 °F to 250 °F
  • Polyester film resists abrasion and chemicals
  • Fits wire sizes from 6/0 to 24 AWG

Specifications

BrandScotchcode
TypeWith Tape
ColorBlack, Blue, Brown, Green, Gray, Orange, Red, Violet, White, Yellow

Questions about this item

How do I apply the Scotchcode STD-C tape to a 24 AWG wire without it slipping?

Pull the pre-printed polyester label from the dispenser, align the adhesive side on the clean wire, and wrap firmly so the acrylic adhesive bonds across the full .22 in width; the step often missed is pressing the overlap for several seconds to activate the adhesive on small diameters.

When will the printed legend on the tape need replacing?

The acrylic adhesive and polyester film are rated from -40 to 250 degrees F, so the marker stays legible until the wire insulation degrades or the label is physically abraded; no scheduled replacement interval applies.

What is the smallest wire gauge the dispenser can reliably mark?

The dispenser fits wire diameters from 6/0 down to 24 AWG; below 24 AWG the .22 in label width may not wrap securely.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.