We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent industrial contactor with screw terminals and DIN rail mounting

Schneider Electric

Schneider Electric Square D TeSys Deca Reversing Contactor 24V AC 32A 3P 1NO/1NC

SKU CH-JQA6-CPCKQ

An IEC reversing contactor rated 32 A inductive and 50 A resistive at 24 V AC with 3 poles, 1NO/1NC auxiliary contacts, screw-clamp terminals and DIN-rail mounting

  • TypeIndustrial Electrical Controls & Automation
  • ColorTransparent
  • Reversing motor control with IEC TeSys Deca design
  • 24 V AC coil voltage for standard control circuits
  • 32 A inductive current rating for demanding loads
  • 3-pole main contacts plus 1NO/1NC auxiliary contacts
  • DIN-rail or plate mounting with screw-clamp terminals

Industrial reversing contactor for motor control

The Schneider Electric TeSys Deca reversing contactor switches three-phase inductive loads up to 32 amps at 24 volts AC. It mounts on DIN rail or a plate and uses screw-clamp terminals for secure wiring. The unit includes one normally-open and one normally-closed auxiliary contact for status feedback. It is built for industrial automation panels that need forward and reverse motor operation.

Replaces single-direction starters

This contactor upgrades a non-reversing starter when an application requires bidirectional motor control. It also replaces an older IEC contactor that no longer switches cleanly or has damaged auxiliary contacts. The jump is worth it when the panel needs a compact 32-amp reversing solution with a 24-volt AC coil and standard screw terminals.

Verify coil voltage and mounting space before

Confirm the control circuit supplies 24 volts AC; a DC coil will not operate this unit. Check that the panel cut-out can accommodate the 3.35 by 3.54 inch footprint on DIN rail or plate mount. Ensure the load does not exceed 32 amps inductive or 50 amps resistive and that screw-clamp terminals suit the wire gauge in use.

Highlights

  • Reversing motor control with IEC TeSys Deca design
  • 24 V AC coil voltage for standard control circuits
  • 32 A inductive current rating for demanding loads
  • 3-pole main contacts plus 1NO/1NC auxiliary contacts
  • DIN-rail or plate mounting with screw-clamp terminals

Specifications

BrandSQUARE D
TypeIndustrial Electrical Controls & Automation
ColorTransparent

Questions about this item

What mounting options suit the 3.35 in by 3.54 in frame?

The contactor mounts on a DIN rail or directly on a plate using the integral mounting feet.

Which terminals accept the coil and power cables?

Screw-clamp terminals accept the 24 V AC coil leads and the three main power conductors; tighten each screw to the torque shown on the label.

When should the auxiliary contact block be inspected or replaced?

Check the 1 NO / 1 NC auxiliary contacts during scheduled panel maintenance; replace the block if contact resistance rises or the contacts show pitting.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.