We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent IEC magnetic contactor, DIN rail mount, screw clamp terminals, 32 A inductive, 480 V AC, 3-pole, 1.77 by 3.35 in

Schneider Electric

Schneider Electric Square D LC1D32T7 32 A 480 V AC 3-pole contactor

SKU CH-NCX9-9STW0

A 32 A inductive, 50 A resistive IEC contactor with 480 V AC coil, three poles, 1NO/1NC auxiliary contacts and DIN-rail or plate mounting

  • TypeIndustrial Electrical Controls & Automation
  • ColorTransparent
  • 32 A inductive rating handles heavy motor loads
  • 50 A resistive capacity supports demanding circuits
  • 480 V AC coil voltage suits industrial power systems
  • 3-pole non-reversing design simplifies three-phase control
  • DIN rail and plate mounting enables flexible panel installation

IEC 32 A 480 V AC contactor

This Schneider Electric Square D LC1D32T7 is a three-pole IEC magnetic contactor rated for 32 A inductive and 50 A resistive loads at 480 V AC. It suits industrial control panels and motor-starter assemblies that require a compact non-reversing switching device. The unit mounts on DIN rail or a plate and uses screw-clamp terminals for secure wiring.

Replaces older non-reversing IEC starters

The contactor provides a direct drop-in for legacy three-pole units with the same coil voltage and pole count when panel space is limited to the 3.35 in height and 1.77 in width envelope. Upgrading is worthwhile when the existing starter lacks the 1NO/1NC auxiliary contacts needed for modern interlock or status-feedback circuits. No enclosure is included, so the swap assumes an existing NEMA-rated cabinet.

Handles 32 A inductive motor loads

The 32 A inductive rating covers typical fractional to medium horsepower motors on 480 V systems, while the 50 A resistive rating supports heating and lighting circuits with comfortable headroom. The two built-in auxiliary contacts manage control-circuit signalling without extra accessories. The device reaches its limit when the application demands reversing operation or a higher inductive current than 32 A.

Highlights

  • 32 A inductive rating handles heavy motor loads
  • 50 A resistive capacity supports demanding circuits
  • 480 V AC coil voltage suits industrial power systems
  • 3-pole non-reversing design simplifies three-phase control
  • DIN rail and plate mounting enables flexible panel installation

Specifications

BrandSQUARE D
TypeIndustrial Electrical Controls & Automation
ColorTransparent

Questions about this item

What DIN-rail width and panel clearance does the 1.77 in wide contactor need?

The unit is 1.77 in wide and 3.35 in tall, so allow that footprint plus wiring space on a standard 35 mm DIN rail or a flat mounting plate.

Which terminals accept the 480 V AC coil leads and the 32 A main poles?

Both coil and power connections use screw-clamp terminals; strip the wire, insert into each clamp, and tighten to the torque printed on the device.

When should the 1NO/1NC auxiliary contacts be checked or replaced?

Inspect the auxiliary contacts during routine panel maintenance; replace them if they show pitting, overheating discoloration, or fail to switch cleanly at 32 A inductive load.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.