We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Transparent IEC control relay with screw terminals for DIN rail mounting

Schneider Electric

Schneider Electric CAD32BD IEC Control Relay 24VDC 10A

SKU CH-ZGM1-YM929

IEC control relay with 3NO/2NC contacts, 10 A AC rating and 24 V DC coil for DIN-rail mounting

  • TypeIndustrial Electrical Controls & Automation
  • ColorTransparent
  • 3 NO / 2 NC contacts enable flexible circuit control
  • 24 V DC coil voltage suits low-voltage automation systems
  • 10 A AC contact rating handles industrial load switching
  • Screw clamp terminals provide secure wiring on DIN rail
  • IP2X rating protects against accidental finger contact

Industrial Control Relay for DIN Rail Automation

The Schneider Electric CAD32BD is a 24 V DC IEC control relay rated at 10 A for AC loads and 2 A for DC loads. It provides three normally open and two normally closed contacts in a transparent housing. The unit mounts on DIN rail or a flat surface and uses screw-clamp terminals for secure wiring.

Upgrade from Lower-Capacity or AC-Coil Relays

This relay replaces older devices that cannot handle 10 A at 600 V AC or 2 A at 600 V DC. The jump is worthwhile when a machine circuit demands higher contact ratings or a 24 V DC coil for direct PLC compatibility. It also suits panels migrating to IEC-standard dimensions and IP2X finger-safe terminals.

Sustained Operation at Elevated Temperature

The relay dissipates 5.4 W coil power and is rated for a maximum ambient temperature of 140 °F. Silver-nickel contacts resist welding during repeated switching cycles. The compact 3.66 in depth, 3.03 in height and 1.77 in width allow dense row mounting without derating the 10 A continuous current.

Highlights

  • 3 NO / 2 NC contacts enable flexible circuit control
  • 24 V DC coil voltage suits low-voltage automation systems
  • 10 A AC contact rating handles industrial load switching
  • Screw clamp terminals provide secure wiring on DIN rail
  • IP2X rating protects against accidental finger contact

Specifications

BrandSchneider Electric
ModelCAD32BD
TypeIndustrial Electrical Controls & Automation
ColorTransparent

Questions about this item

What DIN rail width and panel cut-out suit the 3.66 in deep body?

The relay body measures 3.66 in deep, 3.03 in high and 1.77 in wide, so it clips onto standard DIN rail and fits surface-mount cut-outs matching those dimensions.

Which screw-clamp terminals accept the coil and contact wires, and what tightening step is often missed?

All connections use screw-clamp terminals; the step often missed is tightening each clamp to the specified torque so the 24 V DC coil and the 10 A contacts stay secure.

When should the silver-nickel contacts be inspected or the relay replaced?

Inspect the silver-nickel contacts after extended use at the 10 A AC or 2 A DC ratings, and replace the relay if contact wear or overheating appears near the 140 °F maximum operating temperature.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.