We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten silver F-type coaxial terminator caps with nickel-plated steel finish

SatelliteSale

SatelliteSale 10PACKTERMINATORS 10-pack 75 Ohm F-type coaxial terminator wire cap connector

SKU CH-4AD3-3B1CQ MPN 10PACKTERMINATORS

Pack of ten 75 Ohm F-type coaxial terminators seal unused ports to reduce signal loss and reflection up to 2050 MHz

  • Selling UnitPack
  • Item Count10 pack
  • Materialnickel plated steel
  • TypeCable Connectors
  • FeaturesCoaxial terminator, Round shape connector, ROHS Compliant, n
  • ColorSilver
  • Reduces signal loss and reflection on open ports
  • Nickel-plated steel construction resists corrosion and wear
  • Terminates unused F-type connectors on splitters and amplifiers
  • Compatible with major cable and satellite providers
  • ROHS compliant for safer materials

Universal F-Type 75 Ohm terminators for open ports

This pack supplies ten nickel-plated steel caps that terminate unused F-type connectors on splitters, amplifiers, wall plates and other coaxial equipment. They are built for commercial and residential installations and operate across a 5–2050 MHz range. Each cap is RoHS compliant and designed to resist weather, dust and moisture ingress.

Nickel-plated steel caps reduce signal loss

The terminators stop RF signals from reflecting off open ports, which otherwise degrades picture and data quality on cable, satellite and antenna systems. By sealing each port they keep the line impedance stable and prevent dust or moisture from entering the connector. The result is lower distortion and consistent performance on every connected device.

Check that every open port uses an F-type 75 Ohm

These caps only fit standard F-type female threads, so verify that your splitters, taps, amplifiers and wall outlets share that connector style. Confirm the system impedance is 75 Ohm; other impedances will not match. No tools are required for installation, but each port you intend to close must be accessible and free of damage.

Highlights

  • Reduces signal loss and reflection on open ports
  • Nickel-plated steel construction resists corrosion and wear
  • Terminates unused F-type connectors on splitters and amplifiers
  • Compatible with major cable and satellite providers
  • ROHS compliant for safer materials

Specifications

BrandSatelliteSale
Model10PACKTERMINATORS
Selling UnitPack
Item Count10 pack
Materialnickel plated steel
TypeCable Connectors
FeaturesCoaxial terminator, Round shape connector, ROHS Compliant, nickel plated steel
ColorSilver
Commercial/ResidentialCommercial

Questions about this item

Do the nickel-plated steel caps need periodic replacement to maintain 75 Ohm termination?

The nickel-plated steel construction is designed not to break, pull off, lose signal or become loose over time, so no scheduled replacement is required.

At what frequency does signal reflection become noticeable on these F-type terminators?

They are rated up to 2050 MHz, so reflection stays controlled across the full 5-2050 MHz range used by cable and satellite systems.

Do the caps generate any heat or noise when left on unused ports continuously?

As passive terminators they draw no power, produce no heat and make no noise, even when installed permanently on splitters, amplifiers or wall plates.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.