We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Sanyo PLC-XU106 projector lamp module with housing

Sanyo

Sanyo PLC-XU106 projector lamp 275W 2000 Hrs POA-LMP111

SKU CH-QTZ9-FW47J

A 275 W replacement lamp module with 2,000-hour rated life, supplied as a complete housing for straightforward installation

  • TypeProjector Lamp
  • Wattage275W
  • Lamp Life2,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 275W NSHA lamp delivers specified brightness
  • 2,000-hour rated life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Genuine OEM bulb from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita

Ready-to-install projector lamp module

This replacement module ships as a complete 275W bulb-and-housing assembly for the Sanyo PLC-XU106 projector. It arrives new and fully assembled so no separate lamp alignment is required. The unit matches the original POA-LMP111 part number and fits directly into the projector's lamp compartment.

Rated 2000-hour lamp life at 275W

The NSHA bulb is specified for 2000 hours of operation at its rated 275W power draw. This single figure determines whether the lamp meets your projector's brightness and replacement-interval requirements. Each unit is tested for ignition, voltage and run-time before it leaves the factory.

Consistent output under continuous use

Manufactured to ISO 9001 quality standards, the lamp is validated for stable beam performance during extended projection sessions. OEM-sourced bulbs from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita maintain colour balance and brightness over the full rated life. The module is not suited for users who need a higher-wattage or longer-life alternative than the 275W 2000-hour specification.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 275W NSHA lamp delivers specified brightness
  • 2,000-hour rated life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Genuine OEM bulb from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita

Specifications

BrandSanyo
TypeProjector Lamp
Wattage275W
Lamp Life2,000 Hrs.

Questions about this item

How bright will the 275W lamp actually be in my Sanyo PLC-XU106 projector?

The 275W NSHA bulb delivers the original brightness spec for the PLC-XU106, restoring factory lumen output when installed in the matching housing.

Does the POA-LMP111 module use a proprietary connector or a standard lamp interface?

It uses the exact OEM connector and housing geometry specified for the Sanyo PLC-XU106, so it plugs directly into the projector without adapters.

Will the assembled housing fit the lamp door and mounting screws on my PLC-XU106?

Yes, the complete bulb-and-housing unit matches the original POA-LMP111 dimensions and screw positions for a direct swap.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.