Sanyo
Sanyo PLC-XF47A Projector Lamp 330W 2000 Hrs
A replacement lamp module with a 330 W NSH bulb rated for 2,000 hours of use
- TypeNSH
- Wattage330W
- Lamp Life2,000 Hrs.
- New Ushio NSH 330W bulb delivers bright projection
- 2,000-hour lamp life supports extended use
- Fully assembled housing enables quick installation
- Manufactured to ISO9001 quality standards
- Compatible with Sanyo PLC-XF47A projector
Direct Replacement for Sanyo Projectors
The Sanyo PLC-XF47A lamp module matches the original POA-LMP109 part number and arrives as a fully assembled bulb and housing. It is designed for users who need a straightforward, tool-free swap to restore brightness in compatible Sanyo projectors without sourcing separate components.
Thermals and Power Draw in Normal Use
The NSH bulb operates at 330 W and is rated for 2,000 hours of service life. The housing and bulb are manufactured to ISO 9001 quality checks covering ignition, voltage stability and run-time performance, so the module maintains consistent output within the projector’s original cooling design.
What the Bundled Housing and Testing Change
Because the lamp ships pre-mounted in its housing, installation requires only the projector’s standard lamp-door procedure — no alignment or separate bulb handling. Each unit undergoes beam-performance and connection verification before dispatch, reducing the chance of early failures that can occur with bare-bulb replacements.
Highlights
- New Ushio NSH 330W bulb delivers bright projection
- 2,000-hour lamp life supports extended use
- Fully assembled housing enables quick installation
- Manufactured to ISO9001 quality standards
- Compatible with Sanyo PLC-XF47A projector
Specifications
| Brand | Sanyo |
|---|---|
| Type | NSH |
| Wattage | 330W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How do I install the PLC-XF47A lamp module, and what step do people often miss?
The module arrives fully assembled with the Ushio NSH 330W bulb inside the housing, so you only need to open the projector's lamp door, remove the old unit, slide the new one in until it clicks, and then reset the lamp timer in the menu — skipping the timer reset is the step most people forget.
What maintenance or replacement will this lamp need later?
The NSH 330W bulb is rated for 2,000 hours of use; after that point you replace the entire lamp module again, as the housing is not designed for bulb-only swaps.
What limit appears first during sustained use of this 330W lamp?
The 2,000-hour rated lamp life is the primary limit; brightness will gradually decline and the projector will eventually indicate that a replacement is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



