We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aqua OM3 multimode fibre cable with LC male connectors at both ends, 49.21 ft length

sakose

sakose AQ-LL15 49.21 ft. Aqua OM3 LC/LC MultiMode 50/125 fibre optic cable

SKU CH-ZPET-4WKJ8

A 49.21 ft OM3 multimode fibre patch cable with LC male connectors on both ends, rated for 10 Gbit/s at 850 nm

  • ColorAqua
  • Length49.21 ft.
  • Connector Number2
  • Connector DetailConnector A: 1 - Fiber Optic LC Male Connector B: 1 - Fiber
  • Terminal GenderMale to Male
  • SpeedMaximum Data Transfer Rate: 10Gbps Cable Rating: Fiber - 10
  • Ready for 10 Gbit/s links with OM3 50/125 µm fibre
  • Aqua jacket identifies OM3 multimode at a glance
  • LC male connectors on both ends for standard patch panels
  • 21 ft length suits rack-to-rack runs
  • Male-to-male polarity simplifies installation

Connection type and length

The sakose AQ-LL15 is a 49.21 ft. multimode fibre optic cable built for 10 Gigabit network environments. It uses LC male connectors on both ends and carries an OM3 classification with a 50/125 micron core.

Thermal noise and power characteristics

As a passive optical cable it generates no heat, produces no audible noise and draws no electrical power during normal operation. The aqua jacket identifies the OM3 rating at a glance in crowded patch panels.

Sustained load behaviour

The cable maintains its 10 Gbit/s rating over the full 15 metre run at the 850 nm wavelength specified for OM3 fibre. Signal integrity remains stable for continuous broadband and telecommunication workloads without the degradation seen in copper alternatives.

Highlights

  • Ready for 10 Gbit/s links with OM3 50/125 µm fibre
  • Aqua jacket identifies OM3 multimode at a glance
  • LC male connectors on both ends for standard patch panels
  • 21 ft length suits rack-to-rack runs
  • Male-to-male polarity simplifies installation

Specifications

BrandSAKOSE
ModelAQ-LL15
ColorAqua
Length49.21 ft.
Connector Number2
Connector DetailConnector A: 1 - Fiber Optic LC Male Connector B: 1 - Fiber Optic LC Male
Terminal GenderMale to Male
SpeedMaximum Data Transfer Rate: 10Gbps Cable Rating: Fiber - 10 Gbit/s
SpecificationsFiber Classification: OM3 Fiber Type: Multi Mode Wavelength: 850nm
FeaturesBroadband systems Telecommunication and Data Communication 10 Gigabit High Speed Network Environmnts

Questions about this item

How do I install the 49.21 ft OM3 LC/LC cable without damaging the ceramic ferrules?

Remove the dust caps just before mating, align the key on each LC male connector with the port slot, push straight in until the latch clicks, and never twist or bend the 50/125 µm fibre tighter than the manufacturer's minimum bend radius.

What maintenance or replacement will the aqua OM3 duplex patch cord need later?

Inspect the LC end-faces with a fibre scope before each reconnect, clean with a one-click cleaner if contamination is found, and replace the cord if insertion loss exceeds the OM3 10 Gbit/s link budget or if the 850 nm multimode core shows physical damage.

What limit appears first when the 10 Gbit/s multimode link runs continuously at full load?

The OM3 50/125 µm fibre at 850 nm wavelength reaches its modal bandwidth distance limit before any thermal or connector rating becomes the bottleneck.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.