Ruth's sister
Ruth's sister USB-C PD to 12V 36W 5.5x2.1mm cable 100cm internal power cable
Converts USB-C Power Delivery into 12 V 36 W through a 100 cm cable with a 5.5×2.1 mm barrel connector
- Powers 12 V devices from USB-C PD sources
- Delivers up to 36 W at 12 V output
- 100 cm cable reaches distant equipment
- 5 × 2.1 mm barrel fits common gear
- Works with PD chargers supplying 12 V 1-3 A
Ruth's sister USB-C PD to 12V cable
The Ruth's sister cable converts a USB-C Power Delivery source into a 12V 36W output through a 5.5mm by 2.1mm barrel connector. It measures approximately 100cm in length and is intended for powering compatible routers, laptops, speakers, modems and LED devices from a PD power bank or charger.
Who this suits and who should look elsewhere
This cable suits users who need to run 12V equipment from a portable PD power bank or wall charger while on the move or in remote locations. It is not for buyers whose devices require a different voltage, a higher wattage than 36W, or a barrel connector size other than 5.5mm outer diameter and 2.1mm centre pin.
Deciding specification — 12V 36W output limit
The single specification that decides compatibility is the fixed 12V 36W maximum output. Your PD source must negotiate 12V at 1-3A and your device must draw no more than 36W at 12V; otherwise the cable cannot deliver the required power.
Highlights
- Powers 12 V devices from USB-C PD sources
- Delivers up to 36 W at 12 V output
- 100 cm cable reaches distant equipment
- 5 × 2.1 mm barrel fits common gear
- Works with PD chargers supplying 12 V 1-3 A
Specifications
No published specifications for this item yet.
Questions about this item
What USB-C power source do I need to run this 12V 36W cable?
A USB-C PD charger or power bank that can supply 12V at 1–3A, with total output exceeding your device's power draw.
Will the 5.5 mm outer and 2.1 mm centre-pin jack fit my existing 12V router or speaker?
Yes, the male 5.5×2.1 mm barrel plug matches the common 12V jack used on many routers, speakers, modems and small monitors.
How can I confirm the cable is delivering 12V 36W after I connect it?
The target device powers on and runs normally; if it fails to start or behaves erratically, the PD source may not be negotiating 12V or its wattage is below the device's requirement.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



