We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black ABS box with RJ45 ports and power cable, 75 by 28 by 22 mm

Ruth's sister

Ruth's sister POE Injector Power Splitter 5-48V 1A internal power cable

SKU CH-QKQT-PPCEM

Passive PoE injector and splitter combines 10/100 Mbps data with 5-48 V power up to 1 A for IP cameras and access points

  • Powers IP cameras over a single Ethernet cable
  • Supports 10/100Mbps data rates for network devices
  • Accepts 5-48V input for flexible power sourcing
  • Delivers up to 1A output current for connected equipment
  • Compact 75x28x22mm ABS housing fits tight spaces

PoE Injector for IP Cameras

This passive PoE injector combines data and power over a single RJ45 cable for 10/100Mbps networks. It accepts a wide 5-48V DC input and delivers up to 1A output current to compatible powered devices. The module operates in Mode B with power always active and works with IEEE 802.3af compliant equipment. It suits installers adding IP cameras, wireless access points or VoIP phones to existing Ethernet runs.

Single Unit Simplifies Wiring

The package includes only the injector module itself, measuring 75x28x22mm in a black ABS housing. No external power supply or Ethernet cables are bundled, so the installer must source a suitable 5-48V DC power adapter and patch leads separately. This approach lets you match the power supply precisely to the voltage and wattage your specific camera or access point requires. The bare-board design keeps the installation compact inside enclosures or junction boxes.

Direct Inline Installation

Connect the injector between your network switch and the powered device using standard RJ45 patch cables, then apply DC power to the module's input terminals. The passive design requires no software configuration or driver installation. Ensure the external power supply matches the target device's voltage requirement, as the injector passes the input voltage through without regulation. Verify pinout compatibility for Mode B operation before powering on to avoid damaging sensitive equipment.

Highlights

  • Powers IP cameras over a single Ethernet cable
  • Supports 10/100Mbps data rates for network devices
  • Accepts 5-48V input for flexible power sourcing
  • Delivers up to 1A output current for connected equipment
  • Compact 75x28x22mm ABS housing fits tight spaces

Specifications

No published specifications for this item yet.

Questions about this item

How often should the ABS housing be inspected or replaced?

The ABS housing has no moving parts and no specified service interval; replacement is only needed if physical damage or heat deformation occurs.

What limits continuous 1A output at 48V before the splitter stops delivering power?

The 1A current limit is the first constraint; exceeding it will cause voltage drop or shutdown regardless of thermal conditions.

Does the module generate audible noise or significant heat when powering a camera all day?

It is a passive PoE injector with no fan; operation is silent and heat stays low at the rated 1A load.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.