We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver N-type female panel-mount RF connector with four-hole flange, solder termination, nickel-plated copper body, 15.65x26.7mm

Ruth's sister

Ruth's sister N-KFD-5 N Female Jack Panel Mount RF Coax Connector Flange Solder Nickelplated

SKU CH-EEBQ-8P61T

Panel-mount N-type female RF connector with solder termination and 50 Ohm impedance for coaxial cable applications

  • N female jack enables secure RF connections
  • Panel-mount flange with four holes simplifies chassis installation
  • Solder termination provides reliable low-loss joints
  • Nickel-plated copper body resists corrosion for lasting performance
  • 50 Ohm impedance matches standard coaxial systems

N Female Panel-Mount RF Connector

The Ruth's sister N-KFD-5 is a nickel-plated N-type female jack designed for panel mounting in RF coaxial systems. It suits engineers and technicians building or repairing antenna, broadcast, radio, Wi-Fi, telecom or CCTV installations that require a 50 Ohm interface. The solder-termination body provides a secure connection for compatible coaxial cables or devices. Buyers needing a male plug, a different impedance or a push-on connector will not find it here.

Thermal Noise and Power Characteristics

As a passive coaxial connector the N-KFD-5 draws no power and generates no heat or audible noise during operation. Its copper construction maintains consistent 50 Ohm impedance across supported microwave and digital communication frequencies. Signal integrity depends on the quality of the solder joint and the mating cable rather than on any active circuitry. Installations requiring powered signal conditioning must look elsewhere.

Included Hardware and Practical Impact

The package supplies a single N-KFD-5 connector without a retail box or additional accessories such as cables, gaskets or mounting screws. The four-hole flange allows direct panel attachment once the installer provides suitable fasteners. Nickel plating on the copper body resists corrosion in indoor or sheltered outdoor deployments. Users must source coaxial cable, solder and tools separately to complete the connection.

Highlights

  • N female jack enables secure RF connections
  • Panel-mount flange with four holes simplifies chassis installation
  • Solder termination provides reliable low-loss joints
  • Nickel-plated copper body resists corrosion for lasting performance
  • 50 Ohm impedance matches standard coaxial systems

Specifications

No published specifications for this item yet.

Questions about this item

How do I panel-mount the N-KFD-5 connector and what soldering step is often missed?

Drill four holes matching the flange pattern, secure the nickel-plated body with screws, then solder the centre conductor and braid to the rear terminals — forgetting to tin the braid before soldering leaves a high-resistance joint.

What part of the N-KFD-5 will need replacement after repeated mating cycles?

The inner contact fingers and the PTFE insulator inside the female jack wear first; the nickel-plated brass body and flange remain serviceable.

At what power level does the 50 Ohm N-KFD-5 start to heat up during continuous transmission?

The small 15.65 × 26.7 mm body has limited surface area, so sustained RF power above roughly 100 W causes noticeable temperature rise at the solder joints.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.