Ruth's sister
Ruth's sister M.2 NVMe SATA to U.2 adapter internal power cable
Adapts M.2 NVMe and SATA SSDs to U.2 SFF-8639, supporting 2230, 2242, 2260 and 2280 form factors simultaneously
- Connects M.2 NVMe and SATA drives to U.2 simultaneously
- Supports 2230 2242 2260 2280 form factors on both slots
- Aluminium alloy shell dissipates heat from two SSDs
- Compact 6.5 x 9.7 cm board fits tight chassis
- SFF-8639 interface enables PCIe and SATA bus operation
2-in-1 M.2 to U.2 Adapter Card
This adapter converts M.2 NVMe and M.2 SATA SSDs to a U.2 SFF-8639 interface. It accepts Key M NVMe drives and Key B SATA drives simultaneously. The bare aluminium-alloy board measures approximately 6.5 by 9.7 centimetres and supports 2230, 2242, 2260 and 2280 form factors.
Desktop builders adding U.2 bays
Suits builders who want to run existing M.2 NVMe or SATA drives in a U.2 backplane or hot-swap cage. Not suited for users needing a single-drive M.2 riser, a PCIe x4 card slot or power delivery beyond what the U.2 connector provides.
Fits standard U.2 ecosystems
The card slots into any U.2 SFF-8639 receptacle and draws power through that connection. It frees M.2 slots on the motherboard while letting two drives share one U.2 port. No extra cables or brackets are included in the package.
Highlights
- Connects M.2 NVMe and SATA drives to U.2 simultaneously
- Supports 2230 2242 2260 2280 form factors on both slots
- Aluminium alloy shell dissipates heat from two SSDs
- Compact 6.5 x 9.7 cm board fits tight chassis
- SFF-8639 interface enables PCIe and SATA bus operation
Specifications
No published specifications for this item yet.
Questions about this item
What does the system need to provide at the U.2 SFF-8639 port for the adapter to run both an NVMe and a SATA M.2 drive?
The U.2 SFF-8639 port must supply PCIe lanes for the NVMe drive and SATA signalling for the SATA drive, plus power for the adapter board and both SSDs.
Will an older SATA-only U.2 backplane still let me use the NVMe slot on this adapter?
No — a SATA-only backplane carries no PCIe lanes, so the NVMe M.2 slot would remain inactive while the SATA slot works normally.
How can I confirm both M.2 slots are active after installing a 2280 NVMe drive and a 2242 SATA drive?
Both drives should appear in BIOS and the operating system device list, and each should show its expected transfer mode — PCIe for the NVMe drive, SATA for the other.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115432BTC
In stock
