We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board with 40 pin IDE connector, SATA port and 4 pin power socket, plus SATA cable and power cable

Ruth's sister

Ruth's sister IDE to SATA Converter 40pin 1.5G 160GB international power cord

SKU CH-PWT4-16V8S

Converts 2.5" IDE drives to SATA with a 40-pin interface and 1.5G transfer rate, supporting up to 160GB capacity

  • Connect 2.5" IDE drives via SATA using 40pin interface
  • Power legacy drives with included 4 pin connector
  • Achieve 1.5G data rate with SATA 100/133 support
  • Use drives up to 160GB without driver installation
  • Compact 5.5 x 4.5 cm adapter fits tight spaces

40-pin IDE to SATA converter for 2.5-inch drives

This adapter connects a 2.5-inch IDE hard drive or optical drive to a SATA host interface. It includes a 40-pin IDE connector, a Serial ATA port and a 4-pin power connector. No driver installation is required for operation. The unit supports ATA 100 and 133 standards.

Suitable for upgrading legacy laptops

Users needing to attach a 2.5-inch ATA drive to a modern SATA motherboard or enclosure will find this converter useful. It is not intended for 3.5-inch desktop drives or for drives larger than the stated capacity limit. Builders requiring higher throughput should consider a native SATA device.

Maximum drive capacity limited to 160 GB

The converter enforces a maximum hard-drive capacity of 160 GB, which is the decisive specification for compatibility. Any drive exceeding this limit will not be supported by the adapter. Verify the drive size before purchase to ensure correct function.

Highlights

  • Connect 2.5" IDE drives via SATA using 40pin interface
  • Power legacy drives with included 4 pin connector
  • Achieve 1.5G data rate with SATA 100/133 support
  • Use drives up to 160GB without driver installation
  • Compact 5.5 x 4.5 cm adapter fits tight spaces

Specifications

No published specifications for this item yet.

Questions about this item

Does the 40-pin IDE connector or the 1.5G SATA interface wear out first with daily drive swaps?

The 40-pin IDE connector is rated for far fewer insertion cycles than the SATA port, so it will reach its mechanical limit first.

What limits continuous operation when the adapter runs at the 1.5G per second transfer rate all day?

Sustained throughput is capped by the ATA 100/133 specification and the 160GB drive capacity ceiling, so the interface bandwidth and addressable space set the practical limit.

How much heat and power does the converter draw when it powers a 2.5-inch drive through the 4-pin connector continuously?

The adapter itself is passive and draws negligible power; all heat comes from the attached drive, so thermal output matches that drive's own rating.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.