Ruth's sister
Ruth's sister HDD cable Dell Latitude 3410 07CR4F 450.0KA04.0001
A replacement hard-drive flex cable for Dell Latitude 3410 laptops, connecting the drive to the motherboard
- Compatible with Dell Latitude 3410 and E3410 models
- 100 percent new condition ensures reliable performance
- Flexible cable design fits 9.5 by 1 centimetre space
- Plastic construction provides lightweight durability
- Includes one replacement HDD connector flex cable
Replacement HDD Flex Cable for Dell Latitude 3410
This new internal power cable connects a hard drive to the motherboard in a Dell Latitude 3410 laptop. It matches part numbers 07CR4F and 450.0KA04.0001. The flexible plastic construction fits the tight routing inside the chassis. It is sold as a single piece for repair or upgrade work.
Swaps a damaged or missing original connector
Use this cable when the factory flex ribbon has torn, cracked or lost contact after a drop or repeated lid cycles. The jump is worth it if the drive is detected intermittently or not at all and the drive itself tests healthy. No other laptop models are supported by this specific part.
Simple plug-in installation with delicate alignment
The cable plugs directly into the drive and board connectors without tools or soldering. Route it carefully to avoid pinching the 9.5 cm length under the palm rest or hinge brackets. The most common error is misaligning the fine-pitch pins, which bends contacts and prevents detection.
Highlights
- Compatible with Dell Latitude 3410 and E3410 models
- 100 percent new condition ensures reliable performance
- Flexible cable design fits 9.5 by 1 centimetre space
- Plastic construction provides lightweight durability
- Includes one replacement HDD connector flex cable
Specifications
No published specifications for this item yet.
Questions about this item
Does the 9.5 cm flex cable match the drive bay spacing in a Dell Latitude 3410?
The cable measures 9.5 cm by 1 cm and is listed for the Latitude 3410 and E3410 models, so it aligns with the factory drive bay layout.
Which connector orientation should face the motherboard when fitting the 07CR4F cable?
The narrower end plugs into the motherboard header while the wider end connects to the hard drive; reversing them prevents the latch from engaging.
When should the plastic flex cable be replaced during a drive upgrade?
Replace it if the ribbon shows creases, cracked insulation or corroded pins, otherwise the original cable can be reused with the new drive.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



