We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small square 65mm GPU cooling fan with copper heatsink base and two-pin power connector

Ruth's sister

Ruth's sister FD7015H12S 12V 0.43A 65mm GPU Fan

SKU CH-9ADZ-FTM1G

65 mm 12 V 0.43 A dual-wire cooler with 39 mm mounting for ATI HD 5770 5830 5850 cards

  • TypeCable Extender
  • Direct replacement for ATI HD 5770 5830 5850 cards
  • 12 V 0.43 A draws minimal power from the board
  • 65 mm diameter fits the original mounting holes
  • 39 mm hole spacing matches the factory layout exactly
  • 150 mm two-pin lead reaches the header without strain

Replacement Fan for ATI HD 5770/5850 Series

This 65 mm replacement fan fits ATI HD 5770, HD 5830 and HD 5850 graphics cards. It runs on 12 V DC at 0.43 A and connects via a 2-pin 2.0 mm power connector. The unit includes a 150 mm cable and mounting holes spaced 39 mm centre-to-centre with 2 mm hole size.

Upgrade from Worn or Noisy Original Cooler

Replace the original cooler when bearings become noisy or airflow drops enough to raise GPU temperatures. The copper heatsink base and lower-noise fan design restore stock cooling performance for the listed ATI models. The jump is worth it when the existing fan rattles, spins inconsistently or fails to spin at all.

Check Mounting Holes and Connector Before Ordering

Verify that your card uses the 39 mm mounting pattern and a 2-pin 2.0 mm header before purchase. Confirm the 65 mm by 15 mm frame clears surrounding components on the specific board layout. The 150 mm lead must reach the board header without strain. Buyers needing a different hole spacing, pin count or larger frame cannot use this fan.

Highlights

  • Direct replacement for ATI HD 5770 5830 5850 cards
  • 12 V 0.43 A draws minimal power from the board
  • 65 mm diameter fits the original mounting holes
  • 39 mm hole spacing matches the factory layout exactly
  • 150 mm two-pin lead reaches the header without strain

Specifications

TypeCable Extender

Questions about this item

What is the mounting-hole spacing for the FD7015H12S fan?

The mounting holes are spaced 39 mm centre-to-centre with 2 mm hole diameter.

How do I connect the 2-pin power plug correctly?

Align the 2.0 mm pitch 2-pin connector with the graphics card header and press straight down; reversing the pins will prevent the fan from spinning.

When should I plan to replace the sleeve-bearing fan?

Expect the sleeve-bearing FD7015H12S to last several years; replace it once bearing noise becomes audible or RPM drops below spec.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.