We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow 40-pin IDE ribbon cable with two device connectors

Roby Technology Co., Limited

Roby Technology Co., Limited IDE-YEL-ROBY 40 Pin IDE Cable Yellow

SKU CH-HT2F-3XEZD

Yellow 40-pin IDE ribbon cable connects two drives to a motherboard without drivers

  • TypeCable
  • ColorYellow
  • ConnectorsIDE
  • SpecificationsIDE Cable
  • FeaturesIDE Cable for HDD,VCD,DVD,IPC,PC
  • Connect two IDE drives with one 40-pin cable
  • No driver installation required for immediate use
  • Yellow colour helps identify the cable inside a chassis
  • Supports hard drives and optical drives on the same connector
  • Plug-and-play operation without hot-swap capability

40-Pin IDE Cable for Legacy Builds

This yellow 40-pin IDE ribbon cable connects two IDE devices such as hard drives or optical drives to a motherboard. It is intended for technicians maintaining older PCs, industrial computers or servers that still use parallel ATA interfaces. The cable requires no driver installation and is not hot-swappable. It suits anyone restoring vintage hardware or replacing a failed ribbon in an existing IDE chain.

Driver-Free Plug-and-Play Operation

The cable works immediately after connection without any software setup, reducing downtime during repairs. Its passive design means it adds no configuration steps and draws no extra power. Because hot-swap is not supported, both devices must be connected while the system is powered off. This simplicity benefits field engineers who need a reliable drop-in replacement for damaged original ribbons.

Dual-Device 40-Pin Connector Layout

The single ribbon provides two IDE connectors spaced for a master and slave device on the same channel. This layout decides whether the cable fits the specific drive spacing in your chassis or drive cage. Verify that your motherboard header and device positions match a standard two-connector 40-pin arrangement before ordering.

Highlights

  • Connect two IDE drives with one 40-pin cable
  • No driver installation required for immediate use
  • Yellow colour helps identify the cable inside a chassis
  • Supports hard drives and optical drives on the same connector
  • Plug-and-play operation without hot-swap capability

Specifications

BrandROBYTECH
ModelIDE-YEL-ROBY
Part NumberIDE-cable
TypeCable
ColorYellow
ConnectorsIDE
SpecificationsIDE Cable
FeaturesIDE Cable for HDD,VCD,DVD,IPC,PC

Questions about this item

How often will the 40-pin IDE connectors need to be reseated after repeated drive swaps?

The cable is not hot-swappable, so each drive change requires a full power-down; reseating is only needed if a connection becomes loose over time.

What is the maximum number of IDE devices this cable can support simultaneously?

The ribbon carries two device connectors plus the host connector, allowing exactly two IDE drives or optical units to run at once.

Does the yellow ribbon generate noticeable heat when both attached drives run continuously?

As a passive parallel-ATA ribbon it draws no power of its own, so it adds no measurable heat beyond the drives themselves.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.