We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Red Hat

Red Hat JB8214083CSA 2 in Drain Trap

SKU CH-5PWX-9R7F8 MPN JB8214083CSA

A normally open 2-way solenoid valve with a 2-inch aluminium body and 60 Cv flow capacity for air or inert gas up to 5 psi

  • TypeDrain Components
  • High-flow gas shut-off with 60 Cv capacity
  • 2-way normally open valve for reliable flow control
  • Aluminium body resists corrosion in demanding environments
  • NBR seals compatible with air and inert gas systems
  • 110–120 V AC coil with junction box enclosure

2 in high-flow gas shut-off valve

The Red Hat JB8214083CSA is a normally open, 2-way solenoid valve built for high-flow gas shut-off duties. Its aluminium body and NBR seals suit air or inert gas lines up to a 5 psi differential. The 2 in nominal pipe size and 2 3/32 in orifice match industrial pipework directly. A junction-box coil enclosure simplifies wiring in the field.

Sustained flow at 60 Cv with configurable start

The valve delivers a coefficient of volume of 60, maintaining consistent throughput during continuous operation rather than short bursts alone. Its configurable starting position lets the system designer set the default state to match safety requirements. Rated for 110V AC and 120V AC supplies, the coil holds position reliably across long duty cycles without drift.

Low pressure drop keeps coil temperature modest

At the maximum 5 psi differential the pressure drop across the 2 in orifice remains small, so the solenoid coil runs cooler than on higher-pressure valves. The aluminium body dissipates heat into the gas stream, while the junction-box enclosure contains any audible hum from the AC coil. Power draw stays proportional to the 110–120V AC rating without unexpected inrush spikes.

Highlights

  • High-flow gas shut-off with 60 Cv capacity
  • 2-way normally open valve for reliable flow control
  • Aluminium body resists corrosion in demanding environments
  • NBR seals compatible with air and inert gas systems
  • 110–120 V AC coil with junction box enclosure

Specifications

TypeDrain Components
BrandRed Hat
ModelJB8214083CSA

Questions about this item

How much heat does the coil generate when the valve runs continuously on 120 V AC?

The coil is rated for 110 V AC and 120 V AC operation with a junction-box enclosure that dissipates heat during continuous duty.

What piping and voltage supply must already be on site for this valve to install and operate?

A 2 in nominal pipe connection and a 110 V AC or 120 V AC power source are required for installation and operation.

Will the aluminium body and NBR seals hold up if the valve is added to an existing low-pressure gas line?

The aluminium body and NBR seals are rated for a maximum 5 psi differential on air or inert gas, matching typical low-pressure gas lines.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.