PROXIMA
PROXIMA LX Projector Lamp POA-LMP19 180W 2000 Hrs
Replacement lamp module with a 180 W UHP bulb and housing, rated for 2,000 hours
- TypeProject Lamp
- Wattage180W
- Lamp Life2,000 Hrs.
- Ready-to-install module with bulb and housing included
- 180 W UHP lamp delivers bright projection
- 2,000-hour rated life reduces replacement frequency
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Replacement Lamp for Proxima LX
The Proxima LX replacement lamp module POA-LMP19 arrives as a complete housing with a new 180W UHP bulb installed, so it fits straight into the projector without extra assembly. It is intended for owners of a Proxima LX projector who need a direct, ready-to-fit replacement when the original lamp reaches end of life.
180W UHP bulb rated for 2000 hours
The 180W UHP lamp delivers its rated output for approximately 2000 hours of operation before brightness drops to the replacement threshold. Power draw stays at the specified 180 watts during normal projection, and the module is built to meet ISO 9001 quality checks for ignition, voltage stability and run-time consistency.
Drop-in module frees installation time
Because the bulb comes pre-mounted in its housing, the unit slides into the projector’s lamp bay without handling a bare bulb or aligning separate parts. The design matches the original mechanical interface, so no adapter brackets or firmware updates are required, leaving the owner free to resume projection immediately after the swap.
Highlights
- Ready-to-install module with bulb and housing included
- 180 W UHP lamp delivers bright projection
- 2,000-hour rated life reduces replacement frequency
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Specifications
| Brand | Proxima |
|---|---|
| Type | Project Lamp |
| Wattage | 180W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How do I install the POA-LMP19 lamp module and what step is often missed?
The module arrives as a fully assembled bulb and housing; slide it into the projector until the retaining clip clicks, then reset the lamp-hour counter in the menu so the 2,000-hour rating tracks correctly.
What part will need replacement after the rated life is reached?
The 180W UHP bulb inside the housing is rated for 2,000 hours; once brightness drops or the projector signals end of life, replace the entire POA-LMP19 module.
What limit appears first during continuous operation?
The lamp is rated for 2,000 hours of use; sustained running will reach that hour limit before any other component wears out.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



