Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00939932BTC
In stock
Proline
Proline 107-401NL 1/4" FNPT Brass Ball Valve
A brass inline ball valve with a 316 stainless steel ball rated for 600 psi water and steam service
- TypeOther
- Full-port brass valve handles 600 psi water and steam
- 316 stainless steel ball resists corrosion in gas service
- Two-piece straight body allows inline servicing without pipe removal
- Non-locking manual handle provides simple quarter-turn operation
- Lead-free brass construction meets potable-water safety requirements
What It Is
The Proline 107-401NL is a 1/4-inch FNPT brass ball valve built for inline plumbing. It handles water, steam and combustible gases with a two-piece body and a 316 stainless steel ball. A non-locking handle provides manual two-way control. The valve is rated to 600 psi for both water and steam service.
Who It Suits
This valve suits installers needing a full-port brass valve for 1/4-inch female NPT lines carrying water or steam up to 600 psi. The 316 stainless ball resists corrosion in aggressive media. Buyers who need a locking handle, a vacuum rating, or a 3-A sanitary rating should look at alternative models that carry those certifications.
Deciding Specification
The 600 psi pressure rating for water and steam is the key figure that decides if this valve matches your system requirements. The full-port 316 stainless steel ball and brass body determine media compatibility and flow capacity. Verify that your piping uses 1/4-inch FNPT threads and that 600 psi covers your maximum operating pressure before purchasing.
Highlights
- Full-port brass valve handles 600 psi water and steam
- 316 stainless steel ball resists corrosion in gas service
- Two-piece straight body allows inline servicing without pipe removal
- Non-locking manual handle provides simple quarter-turn operation
- Lead-free brass construction meets potable-water safety requirements
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Other |
Questions about this item
How do I install the 1/4" FNPT ball valve without damaging the brass threads?
Wrap PTFE tape clockwise on the male threads only, thread the valve on by hand until snug, then tighten one to two turns with a wrench on the valve body flats — never on the handle.
What maintenance will the 316 stainless steel ball and brass body need over time?
Cycle the handle fully open and closed every few months to prevent seizing; inspect the packing nut for weeping and tighten it slightly if a leak appears.
At what pressure limit should I expect the valve to become the bottleneck in a 600 psi water system?
The valve is rated for 600 psi water and steam, so it matches the line rating; the practical limit is the 600 psi operating pressure stamped on the body.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
