We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver aluminium ceiling mount with adjustable swivel arm, four-inch drop, projector plate visible

Projector Ceiling Mounts Direct, LLC.

Projector Ceiling Mounts Direct VIVITEK-DX28CAA projector accessory

SKU CH-YQA3-0B0AT

Ceiling mount positions compatible Vivitek projectors four inches down with 360-degree swivel and ±35-degree tilt from CNC-machined 6061-T6 aluminium

  • TypeProjector Mounts
  • Secure 360° positioning with fully adjustable swivel
  • Precise fit via CNC-machined 6061-T6 aluminium plate
  • Quick setup with all hardware and instructions included
  • Low 4-inch ceiling drop keeps projector close
  • Dedicated compatibility with Vivitek DX28CAA MH588 MS580 MW584 MW596ST MX581

Ceiling mount for Vivitek projectors

This CNC-machined 6061-T6 aluminium mount is built specifically for the Vivitek DX28CAA, MH588, MS580, MW584, MW596ST and MX581 models. It positions the projector roughly 4 inches from the ceiling and includes all hardware plus detailed instructions for drywall or wooden-beam installation. The design leaves room for heat to escape while keeping the projector secure.

Who this suits and who should look elsewhere

Installers fitting one of the listed Vivitek models onto a solid ceiling will appreciate the precise fit, 360-degree rotation and ±35-degree pitch and roll adjustment. Buyers with drop or false ceilings, or those owning any projector not named above, need a different mounting solution because the plate will not align and the hardware is not rated for suspended grids.

Capacity and headroom

The mount handles the weight and mounting-hole pattern of the six compatible Vivitek units with a rigid aircraft-grade plate and full swivel range. It runs out of headroom when the ceiling is a suspended tile system, when the projector model differs from the approved list, or when a greater drop distance than the fixed 4-inch offset is required.

Highlights

  • Secure 360° positioning with fully adjustable swivel
  • Precise fit via CNC-machined 6061-T6 aluminium plate
  • Quick setup with all hardware and instructions included
  • Low 4-inch ceiling drop keeps projector close
  • Dedicated compatibility with Vivitek DX28CAA MH588 MS580 MW584 MW596ST MX581

Specifications

TypeProjector Mounts

Questions about this item

What projector models does this ceiling mount support?

The mount fits Vivitek DX28CAA, MH588, MS580, MW584, MW596ST and MX581 projectors only.

How far does the mount hold the projector from the ceiling?

The projector sits approximately 4 inches below the ceiling surface.

How can I verify the mount is installed correctly?

The projector should rotate a full 360 degrees and tilt plus or minus 35 degrees without obstruction.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.