We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver aluminium projector ceiling mount with 10 inch extension arm and adjustable tilt joint

Projector Ceiling Mounts Direct, LLC.

Projector Ceiling Mounts Direct OPTOMA-TH1060p-MM-10EXT projector accessory

SKU CH-DQHJ-7B2W5

Aircraft-aluminium ceiling mount positions compatible Optoma TH1060p TX779 TX779-3D projectors 10 inches down with 360-degree rotation and ±80-degree tilt

  • TypeProjector Mounts
  • Designed for Optoma TH1060p, TX779 and TX779-3D projectors
  • 10-inch extension positions projector 10 inches from ceiling
  • 360-degree rotation with ±80-degree tilt for flexible aiming
  • 6061-T6 aircraft-grade aluminium plate machined for exact fit
  • All mounting hardware and instructions included for quick setup

Optoma-Specific Ceiling Mount

This projector ceiling mount is engineered exclusively for Optoma TH1060p, TX779 and TX779-3D models. It uses a CNC-machined plate cut from 6061-T6 aircraft aluminium to match the mounting points of those units. The design keeps projector coverage minimal while preserving airflow around the chassis. All fixings for drywall or wooden beams are supplied with step-by-step instructions.

Installers Needing a Dedicated Fit

The mount suits technicians and home-cinema owners who want a secure, model-specific installation without universal adapters. It is not intended for drop or false ceilings, so installers working with suspended-grid systems should look elsewhere. Buyers with any projector outside the three listed Optoma models will find the plate incompatible and must seek a different mounting solution.

Ten-Inch Drop With Full Articulation

The bracket positions the projector roughly 10 inches below the ceiling surface. A 360-degree rotation joint combines with pitch and roll adjustment up to 80 degrees in either direction for precise image alignment. This range handles most ceiling-to-screen geometries in typical rooms. Extreme angles or very high ceilings may exceed the available tilt and require an alternative mounting approach.

Highlights

  • Designed for Optoma TH1060p, TX779 and TX779-3D projectors
  • 10-inch extension positions projector 10 inches from ceiling
  • 360-degree rotation with ±80-degree tilt for flexible aiming
  • 6061-T6 aircraft-grade aluminium plate machined for exact fit
  • All mounting hardware and instructions included for quick setup

Specifications

TypeProjector Mounts

Questions about this item

What projector models must I already own for this OPTOMA-TH1060p-MM-10EXT mount to fit?

This mount is designed only for Optoma TH1060p, TX779 and TX779-3D projectors; it will not fit any other make or model.

How does the mount behave alongside the projector's own cooling when installed?

The CNC-machined 6061-T6 aluminium plate uses minimal coverage and leaves adequate space for heat to escape, so the projector's cooling is not obstructed.

How can I verify the mount is working as intended after I set it up?

The projector should sit approximately 10 inches from the ceiling and rotate 360 degrees with tilt adjustable to +/- 80 degrees without binding.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.