We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver aluminium projector ceiling mount with adjustable swivel arm, shown without projector

Projector Ceiling Mounts Direct, LLC.

Projector Ceiling Mounts Direct EPSON-EB-118 projector accessory

SKU CH-7VD1-DZREF

Ceiling mount positions compatible Epson projectors 10 centimetres down with 360-degree swivel and ±35-degree tilt from CNC-machined 6061-T6 aluminium

  • TypeProjector Mounts
  • Precise fit for listed Epson models
  • 360-degree rotation with ±35° pitch and roll
  • CNC-machined 6061-T6 aluminium plate for strength
  • Sets projector roughly 4 inches from ceiling
  • All hardware and instructions included for quick install

Direct-fit ceiling mount for Epson projectors

This ceiling mount is built specifically for the Epson EB-118, 972, 982W, 992F, E01, E10, E20, E500 and FH06 models. The CNC-machined 6061-T6 aircraft-grade aluminium plate matches the mounting points of those units exactly. All required hardware and detailed instructions are included for a straightforward installation onto drywall or a wooden beam. It is not intended for drop or false ceilings.

Fixed 4-inch drop with full 360-degree orientation

The mount positions the projector approximately 4 inches from the ceiling and provides a fully adjustable 360-degree swivel. Pitch and roll can be set within a +/- 35 degree range, allowing precise image alignment without moving the ceiling bracket. Because the plate is tailored to the listed models only, the projector sits securely with minimal coverage of its chassis.

Open design preserves projector cooling

The custom plate leaves adequate space around the projector vents so that heat can escape normally during operation. No moving parts or fans are added, so the mount itself contributes no noise or power draw. Builders who need a shorter or longer drop, or who are mounting to a suspended ceiling grid, will need a different solution.

Highlights

  • Precise fit for listed Epson models
  • 360-degree rotation with ±35° pitch and roll
  • CNC-machined 6061-T6 aluminium plate for strength
  • Sets projector roughly 4 inches from ceiling
  • All hardware and instructions included for quick install

Specifications

TypeProjector Mounts

Questions about this item

Does the mount block airflow and make the Epson EB-118 run hotter after hours of use?

The CNC-machined 6061-T6 aluminium plate is designed with minimal coverage so heat can escape freely; the projector sits about 4 inches from the ceiling, preserving normal airflow.

What tools or extra parts do I need before I can hang this mount on a drywall ceiling?

All mounting hardware for drywall or wooden beams is included in the box along with detailed instructions; you only supply basic hand tools such as a drill and screwdriver.

Will this mount still fit if I replace the EB-118 with an older Epson 972 or 982W later?

Yes — the mount is machined specifically for the EB-118, 972, 982W, 992F, E01, E10, E20, E500 and FH06 models, so any of those projectors will attach directly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.