PROJECTIONDESIGN
PROJECTIONDESIGN F20 SX+ 003-120181-01 projector lamp 220W 2000 Hrs
A 220 W replacement lamp module with a 2000-hour rated life, supplied as a complete housing for direct installation
- TypeProjector Lamp
- Wattage220W
- Lamp Life2,000 Hrs.
- Ready-to-install module with bulb and housing
- 220 watt UHP lamp delivers specified brightness
- 2000 hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Genuine Philips bulb ensures reliable ignition
Replacement Lamp for F20 SX+ Projector
This new 220 W lamp module fits the Projectiondesign F20 SX+ projector and arrives as a fully assembled bulb and housing. It is ready for immediate installation without additional tools or alignment steps. The unit is built to ISO 9001 quality standards and uses a genuine Philips UHP bulb for reliable ignition and consistent beam performance.
2 000 Hour Rated Lamp Life
The lamp is rated for 2 000 hours of operation at its specified 220 W power draw. This figure determines how long the projector can run before brightness drops to half of its initial output. Buyers who need longer intervals between replacements should verify whether their projector supports an alternative lamp with a higher hour rating.
Pre Assembled Housing Simplifies Swap
Because the bulb comes pre mounted in its housing the installer only needs to remove the old module and insert the new one. No separate bulb handling or housing reuse is required which reduces the risk of contamination or misalignment. The package contains the lamp module only; no additional cables filters or software are included.
Highlights
- Ready-to-install module with bulb and housing
- 220 watt UHP lamp delivers specified brightness
- 2000 hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Genuine Philips bulb ensures reliable ignition
Specifications
| Brand | Projectiondesign |
|---|---|
| Type | Projector Lamp |
| Wattage | 220W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What brightness and runtime can I expect from the 220 W lamp once it is installed in my projector?
The module uses a 220 W Philips UHP bulb rated for 2000 hours of operation.
Does the lamp use a standard socket or a proprietary connector that limits which projectors it fits?
It is supplied as a complete bulb-and-housing assembly built to the Projectiondesign 003-120181-01 specification for direct replacement.
What physical space and mounting points does the module need inside the projector?
The pre-assembled housing matches the original F20 SX+ form factor so it slots into the existing lamp compartment without modification.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
