We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Six 30 inch rigid PETG tubes in blood red, 1/2 inch OD with 1/16 inch wall

PrimoChill

PrimoChill 1/2in OD PETG Tube 6 x 30in Blood Red

SKU CH-571R-A1YHY

Six 30-inch lengths of 1/2-inch OD PETG tubing in Blood Red for custom watercooling loops

  • TypeCPU Block
  • Vivid Blood Red colour matches any themed build
  • Superior strength over acrylic resists cracking under pressure
  • Thicker 1/16 in. wall adds safety margin for high-pressure loops
  • Six 30 in. lengths give ample material for complex routing
  • Compatible with standard 1/2 in. OD rigid compression fittings

Rigid PETG tubing for custom loops

PrimoChill 1/2in OD PETG tube comes in six 30in lengths coloured Blood Red. The virgin PETG material offers superior strength to acrylic while remaining non-toxic and environmentally responsible. Proudly made in the USA with a thicker wall for safer operation under pressure.

For builders who want tight bends without extra

Suits enthusiasts and case modders who measure, cut, bend and install rigid runs in a single loop. Not for buyers who need flexible tubing that routes around obstacles without heat tools, or anyone requiring a different outer diameter or wall thickness.

Heat-bend installation

Compatible with PrimoChill 1/2in OD rigid compression fittings for secure connections. A heat gun is required to form 90 degree bends or custom angles before cutting to length. Take care not to overheat the PETG, which can cause kinking or discolouration during the bend.

Highlights

  • Vivid Blood Red colour matches any themed build
  • Superior strength over acrylic resists cracking under pressure
  • Thicker 1/16 in. wall adds safety margin for high-pressure loops
  • Six 30 in. lengths give ample material for complex routing
  • Compatible with standard 1/2 in. OD rigid compression fittings

Specifications

TypeCPU Block

Questions about this item

What inner-diameter tubing and fittings must I already have for this 1/2in OD PETG tube to work?

You need 3/8in inner-diameter tubing and 1/2in OD rigid compression fittings to match the tube dimensions.

Will this Blood Red PETG tube connect to older acrylic tubing I plan to keep in the loop?

It joins only through 1/2in OD rigid fittings; the PETG tube itself cannot mate directly to acrylic tubing of any size.

How can I confirm the tube is seated correctly after bending and installing the six 30in pieces?

Verify each joint shows no gaps at the compression fitting and that coolant flows without leaks under system pressure.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.