We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two new DLP replacement lamps in bare housing finish

PowerWarehouse

PowerWarehouse Sanyo PLC-WL2500A dlp replacement lamp 2pcs

SKU CH-J225-6AC6K

Two DLP replacement lamps compatible with Sanyo PLC-WL2500A projectors

  • TypeLamps
  • SpecificationsReplaces OEM# POA-LMP141, POALMP141, 610-349-0847, 610349084
  • Replaces OEM lamp POA-LMP141 directly
  • Two lamps included for spare or dual use
  • 100 % compatible with original equipment
  • Fits Sanyo PLC-WL2500A projector models

Two-lamp replacement set for Sanyo projectors

This pack contains two new DLP replacement lamps built to match the original Sanyo PLC-WL2500A module. Each lamp is fully compatible with OEM references POA-LMP141, POALMP141, 610-349-0847 and 6103490847. The pair lets you restore brightness on one projector and keep a spare ready for the next change.

Upgrades dim or failed original lamps

Install these when the factory lamp reaches end of life or when image output has faded beyond acceptable levels. The jump is worth it if the projector is otherwise working and a single lamp change returns it to full brightness. Not suited for users whose projector has colour-wheel, DMD or power-supply faults that a lamp swap cannot fix.

Highlights

  • Replaces OEM lamp POA-LMP141 directly
  • Two lamps included for spare or dual use
  • 100 % compatible with original equipment
  • Fits Sanyo PLC-WL2500A projector models

Specifications

ModelSanyo PLC-WL2500A POA-LMP141, POALMP141, 610-349-0847, 6103490847
TypeLamps
SpecificationsReplaces OEM# POA-LMP141, POALMP141, 610-349-0847, 6103490847

Questions about this item

Does this lamp module slide into the same housing as the original POA-LMP141 unit?

Yes, it is built to match the OEM POA-LMP141 form factor so it seats in the projector's existing lamp cage without adapters.

Which way does the connector face when you insert the lamp, and what click confirms it is seated?

Align the connector toward the rear of the compartment, push firmly until the retaining latch snaps audibly, then close the cover and reset the lamp timer.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.