We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
PowerWarehouse ELPLP10S308 projector lamp module with silver housing and glass lens

PowerWarehouse

PowerWarehouse ELPLP10S308 DLP Replacement Lamp 120W for Epson EMP-700

SKU CH-3WNJ-HKYVA

120 W replacement lamp rated for 2000 hours on the EMP-700 projector

  • TypeLamps
  • Specifications120 Watt
  • 120 W lamp powers the Epson EMP-700 projector
  • Rated 2000 hours of projection time
  • Designed as a direct replacement for the EMP-700
  • Brand-new unit from PowerWarehouse

Direct-fit replacement for EMP-700 projectors

The PowerWarehouse ELPLP10S308 lamp is built as a 120-watt direct replacement for the Epson EMP-700 projector. It restores original brightness and colour performance when the factory lamp reaches end of life. The unit is supplied new and rated for 2000 hours of typical operation.

Swaps the original 120 W module when brightness

Replace the lamp when the image dims, colours shift or the projector warns that lamp hours are exhausted. The change is worth it if the projector optics and electronics are still sound and a full hardware upgrade is not required. Buyers needing higher lumen output or a different throw ratio will need a different projector rather than a lamp swap.

Highlights

  • 120 W lamp powers the Epson EMP-700 projector
  • Rated 2000 hours of projection time
  • Designed as a direct replacement for the EMP-700
  • Brand-new unit from PowerWarehouse

Specifications

BrandPowerWarehouse
ModelELPLP10S308
TypeLamps
Specifications120 Watt

Questions about this item

Does the ELPLP10S308 lamp housing match the original EMP-700 module dimensions?

The ELPLP10S308 is built as a direct replacement for the EMP-700 projector, so the housing aligns with the factory lamp compartment and mounting points.

What is the correct installation sequence for the 120W lamp, and which step is most often missed?

Power off and cool the EMP-700, remove the lamp cover, release the retaining screws, swap the ELPLP10S308 module, re-tighten screws, replace the cover, then reset the 2000-hour timer in the menu — the timer reset is the step most often missed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.