PowerWarehouse
PowerWarehouse DLP Replacement Lamp for Mitsubishi X30 130W 1000h
Replacement DLP lamp for Mitsubishi X30 projectors, rated at 130 watts with a 1000-hour service life
- TypeLamps
- Specifications130 Watt
- 130 W lamp powers bright, clear projection for Mitsubishi X30
- Rated 1000 hours of use before replacement is needed
- Quality-tested components ensure reliable, consistent performance
- Built to meet OEM requirements for full compatibility
- Model 878438046552 identifies the exact replacement part
Compatible Mitsubishi X30 projector lamp
This 130-watt UHP replacement lamp is built for the Mitsubishi X30 projector. It restores original brightness when the factory lamp reaches end of life. Installation follows the projector's standard lamp-change procedure. The lamp ships new and ready to fit.
1000-hour rated life at 130 watts
The lamp is rated for 1000 hours of operation at its 130-watt specification. Brightness will gradually decline as the lamp ages past this point. Users running the projector for many hours daily should plan a spare to avoid interruption. Economy modes, if offered by the projector, may extend usable life.
Direct OEM-spec replacement for the original lamp
This unit matches the OEM requirements for the Mitsubishi X30, so it replaces the factory lamp without modification. It is not a higher-wattage upgrade and does not increase native resolution or contrast. Buyers needing longer rated life or higher brightness should verify whether the projector supports alternative lamp options.
Highlights
- 130 W lamp powers bright, clear projection for Mitsubishi X30
- Rated 1000 hours of use before replacement is needed
- Quality-tested components ensure reliable, consistent performance
- Built to meet OEM requirements for full compatibility
- Model 878438046552 identifies the exact replacement part
Specifications
| Brand | PowerWarehouse |
|---|---|
| Model | 878438046552 |
| Type | Lamps |
| Specifications | 130 Watt |
Questions about this item
Will this 130 Watt lamp run in my Mitsubishi X30 without overheating the original housing?
The lamp is rated at 130 Watt and built to OEM requirements, so it matches the thermal design of the original Mitsubishi X30 module.
How can I confirm the lamp is performing correctly once installed?
Reset the projector’s lamp timer after fitting the unit; the counter should start from zero and the image should reach full brightness with no warning indicators.
Does the package include the bare bulb only or a complete housing, and do I need any extra tools?
The product is supplied as a complete replacement lamp module ready to install; no separate housing or special tools are required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



