PowerWarehouse
PowerWarehouse DLP Replacement Lamp 100 Watt for Samsung HLP4674WX
A 100 watt DLP replacement lamp with bulb and housing for the Samsung HLP4674WX television
- TypeLamps
- Specifications100 Watt
- 100 Watt output matches the original TV specification
- Includes both bulb and housing for straightforward installation
- Tested by quality control before packaging and shipping
- Guaranteed 100% compatible with Samsung HLP4674WX model
- Meets OEM requirements for reliable performance
Compatible DLP Lamp for Samsung HLP4674WX
This PowerWarehouse replacement lamp is built for the Samsung HLP4674WX rear-projection television. It arrives as a complete assembly with bulb and housing so no extra parts are needed. The unit is tested by the supplier quality team before it leaves the factory. It meets the original equipment requirements for fit and function.
Ideal for owners restoring original brightness
The lamp suits anyone whose Samsung HLP4674WX has dimmed or shows a replacement warning. It is not intended for other television models or for projector housings that use a different connector or wattage. Buyers needing a higher-output module or a bare bulb without housing should look elsewhere.
Rated at 100 Watt for direct OEM replacement
The single deciding specification is the 100 Watt power rating matched to the original lamp. This figure determines whether the lamp will ignite correctly and maintain the designed light output. Confirm the model number HLP4674WX on your set before ordering.
Highlights
- 100 Watt output matches the original TV specification
- Includes both bulb and housing for straightforward installation
- Tested by quality control before packaging and shipping
- Guaranteed 100% compatible with Samsung HLP4674WX model
- Meets OEM requirements for reliable performance
Specifications
| Brand | PowerWarehouse |
|---|---|
| Model | 878439140419 |
| Type | Lamps |
| Specifications | 100 Watt |
Questions about this item
How do I install the 100 Watt lamp in my HLP4674WX, and what step do people often miss?
Remove the lamp cover, unscrew the old module, slide the new housing in until it seats firmly, then tighten the retaining screws before replacing the cover — skipping the screw‑tightening step causes the lamp to shift and the TV to refuse to start.
What maintenance or replacement will this 100 Watt DLP lamp need later?
The lamp itself is the only replaceable part; once brightness drops noticeably after its rated hours, install a new 100 Watt PowerWarehouse module — no filters or other consumables are required for this HLP4674WX model.
What limit shows up first during long viewing sessions with this 100 Watt lamp?
The lamp’s thermal protection will dim or shut off the picture if the TV’s internal cooling cannot dissipate the 100 Watt heat load during extended use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



