PowerWarehouse
PowerWarehouse 310-6472 200 Watt 2000 Hrs DLP Replacement Lamp
Replacement DLP projector lamp rated 200 watts with 2000-hour rated life
- TypeLamps
- Specifications200 Watt
- Bright projection with 200 Watt UHP lamp
- Long viewing life rated at 2000 hours
- Exact fit for 310-6472 projector models
- Quality tested to meet OEM requirements
- New replacement lamp ready for installation
Exact Fit for 310-6472 Projectors
This PowerWarehouse lamp is a direct replacement for projectors using the 310-6472 part number. It delivers 200 Watt output and a rated 2000 hour lifespan. The unit arrives new and is tested to meet original equipment specifications. Installers can swap it in without modifications.
Upgrade from Dim or Expired Lamps
When an existing lamp falls below usable brightness or reaches its hour limit, this module restores full output. The jump is worth it when the projector image has become too dim for presentations or home viewing. It replaces the original UHP lamp on a one-for-one basis. No firmware changes or housing alterations are required.
Limits of UHP Lamp Technology
UHP lamps gradually lose brightness over the 2000 hour rating rather than maintaining peak output. Colour balance can shift as the bulb ages, requiring periodic calibration. The projector must provide adequate ventilation to reach the rated life. Users needing longer maintenance intervals should consider laser or LED light engines instead.
Highlights
- Bright projection with 200 Watt UHP lamp
- Long viewing life rated at 2000 hours
- Exact fit for 310-6472 projector models
- Quality tested to meet OEM requirements
- New replacement lamp ready for installation
Specifications
| Brand | PowerWarehouse |
|---|---|
| Model | 878438777296 |
| Type | Lamps |
| Specifications | 200 Watt |
Questions about this item
What projector models does the 310-6472 lamp fit?
The lamp is a direct replacement for projectors that specify the 310-6472 part number.
What is the correct way to install the 200 watt UHP lamp?
Power off and cool the projector, remove the lamp cover, slide out the old module, insert the new one until it seats firmly, then replace the cover before resetting the hour counter.
When should I replace the lamp again after 2000 hrs of use?
Plan a replacement when the projector warns of end-of-life or brightness drops noticeably, typically around the rated 2000 hours.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



