We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
PowerBass PS-10 10 inch car subwoofer with paper cone and steel basket

PowerBass

PowerBass PS-10 10" car subwoofer 450W RMS 4 Ohm

SKU CH-XMVV-6ACCP

A 10-inch paper-cone car subwoofer rated 450 W RMS and 900 W peak at 4 ohms with 90 dB sensitivity and 33–500 Hz response

  • TypeWoofer
  • Cone Material10" Paper Woofer
  • Peak Power450W
  • RMS PowerPS-10
  • Sensitivity90 dB
  • Impedance4 Ohm
  • Deep bass from 33 Hz low-frequency response
  • 450 W RMS power handling for sustained output
  • 90 dB sensitivity produces high volume with less power
  • 110 oz magnet structure delivers strong motor force
  • 2-inch BASV voice coil handles high thermal loads

What the PS-10 delivers

The PowerBass PS-10 is a 10 inch paper-cone car subwoofer rated for 450 W RMS and 900 W peak power at 4 ohms. Its 90 dB sensitivity and 33–500 Hz frequency response make it a straightforward upgrade for factory or aftermarket systems that need deeper bass without specialised enclosures.

Who it suits and who it does not

The single 4 ohm voice coil suits amplifiers stable at that load and enclosures built to the industry-standard cutout. Buyers who need dual voice coils for wiring flexibility, higher sensitivity for low-power head units, or a smaller mounting depth should look at alternative designs.

Behaviour under sustained load

A 2 inch BASV voice coil on an extended vented pole motor assembly helps dissipate heat during long listening sessions. The progressive flat spider and ribbed DDC-treated paper cone maintain linear excursion, while the precision steel basket with aeroventing keeps the motor cool when the subwoofer runs near its 450 W RMS rating.

Highlights

  • Deep bass from 33 Hz low-frequency response
  • 450 W RMS power handling for sustained output
  • 90 dB sensitivity produces high volume with less power
  • 110 oz magnet structure delivers strong motor force
  • 2-inch BASV voice coil handles high thermal loads

Specifications

BrandPowerBass
SeriesPS
TypeWoofer
Cone Material10" Paper Woofer
Peak Power450W
RMS PowerPS-10
Sensitivity90 dB
Impedance4 Ohm

Questions about this item

What amplifier power rating do I need to drive the 450 W RMS subwoofer?

Choose an amplifier that delivers around 450 W RMS at 4 ohms so the subwoofer receives its rated continuous power without clipping.

Can I keep my factory head unit and just add this 10" subwoofer?

Yes, but you will need a line-output converter or an amplifier with high-level inputs to connect the factory speaker wires to the amp that powers this 4 ohm woofer.

How do I confirm the subwoofer is performing correctly after installation?

Play a 33 Hz test tone and verify clean output; the woofer should reproduce frequencies up to 500 Hz without distortion when the amplifier gain is set properly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.