PowerBass
PowerBass 2XL673 6.75" coaxial car speaker pair
A 6.75-inch coaxial speaker pair rated at 150 watts RMS with a 1-inch silk dome tweeter and 89 dB sensitivity
- Type6.75"
- Speaker Size6.75"
- 300 W peak power handles loud transients
- 150 W RMS per pair sustains clean output
- 1" Emperor's Silk Dome tweeter extends highs to 20 kHz
- Non-woven wool paper cone with butyl rubber surround resists fatigue
- 3-ohm impedance draws more power from factory amplifiers
Speaker Pair for Door & Deck Openings
The PowerBass 2XL673 is a 6.75-inch coaxial speaker pair built for factory door or rear-deck locations. Each unit combines a non-woven wool paper cone with a 1-inch Emperor’s Silk dome tweeter. The 3-ohm nominal impedance draws more current from a standard head unit for higher output. Sold as a matched pair for balanced stereo imaging.
Thermal & Power Behaviour in Daily Use
The heavy motor structure and butyl rubber surround dissipate heat during extended play at 75 watts RMS per speaker. Peak handling reaches 150 watts per unit without mechanical failure. The non-resonant basket reduces cabinet vibration that can colour midrange. Sensitivity of 89 dB at one watt and one metre keeps amplifier demand moderate.
Shallow Mounting Depth Constraint
A mounting depth of 1.9 inches fits tight door cavities where deeper baskets cannot clear window mechanisms. The 12-ounce magnet and PBX custom mesh grill add minimal protrusion. Frequency response spans 60 Hz to 20 kHz for full-range coverage without a separate subwoofer. Buyers needing deeper bass extension or component separation should consider alternative designs.
Highlights
- 300 W peak power handles loud transients
- 150 W RMS per pair sustains clean output
- 1" Emperor's Silk Dome tweeter extends highs to 20 kHz
- Non-woven wool paper cone with butyl rubber surround resists fatigue
- 3-ohm impedance draws more power from factory amplifiers
Specifications
| Brand | PowerBass |
|---|---|
| Type | 6.75" |
| Speaker Size | 6.75" |
Questions about this item
How do I install the 6.75" coaxial speakers and what mounting depth mistake should I avoid?
The speakers need a 1.9" mounting depth; measure the door cavity before cutting to ensure the heavy motor structure clears the window mechanism and wiring harness.
What maintenance will the butyl rubber surrounds and silk dome tweeters need over time?
Butyl rubber resists drying and cracking far longer than foam, so the surrounds rarely need replacement; the silk dome tweeters have no ferrofluid to dry out, leaving only occasional grille cleaning.
At what power level does the 3-ohm impedance first stress a typical head-unit amplifier during sustained playback?
With 75 W RMS per speaker and 89 dB sensitivity, the 3-ohm load draws significantly more current than 4-ohm models, so many factory amplifiers hit current limits or thermal protection well below the 150 W peak rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PAC APH-TY02 Speaker Connection Harness Toyota Lexus 18
- Car Stereo Add-Ons
The Wires Zone Platinum 1/0 AWG Ring Terminals Pair
- Connector and Termi…



