Pomona Electronics
Pomona Electronics 5523 Mini Grabber Patch Cord Kit 24 in 10 Colors
Ten 24-inch mini grabber patch cords in assorted colours with gold-plated beryllium copper clips, rated 300 Vrms and 216 °F
- TypeElectronic
- Equipment TypeTest Probes & Leads
- 10 assorted colours for quick circuit identification
- 24-inch gold-plated leads rated to 300 Vrms
- Mini grabber clips with beryllium copper contacts
- 20 AWG PVC-insulated wire handles up to 216 °F
- Complete 10-piece kit ready for bench testing
Mini grabber patch cord kit
The Pomona Electronics 5523 kit provides ten mini-grabber patch cords for test and measurement tasks. Each cord uses a test clip at both ends and suits engineers, technicians and students who need quick, colour-coded connections during circuit debugging or bench work.
Build quality and daily handling
Gold-plated beryllium copper contacts and PVC insulation are rated for 300 Vrms and temperatures up to 216 degrees Fahrenheit. The 20 AWG wire and 24 inch length give enough reach for typical bench setups while the ten distinct colours simplify signal tracing and reduce wiring errors.
Replacing loose leads and when the kit pays off
The kit replaces individual clip leads that tangle or lack consistent colour coding. Buying the 5523 makes sense when a project demands multiple simultaneous test points and a single pack of ten assorted cords keeps the workspace organised without ordering separate part numbers.
Highlights
- 10 assorted colours for quick circuit identification
- 24-inch gold-plated leads rated to 300 Vrms
- Mini grabber clips with beryllium copper contacts
- 20 AWG PVC-insulated wire handles up to 216 °F
- Complete 10-piece kit ready for bench testing
Specifications
| Brand | Pomona Electronics |
|---|---|
| Model | 5523 |
| Type | Electronic |
| Equipment Type | Test Probes & Leads |
Questions about this item
What voltage does the 300 Vrms rating on the 5523 kit allow for measurement work?
The cords are rated for 300 Vrms, so they suit low-voltage bench testing and signal tracing within that limit.
How much space do the 24 inch cords with mini grabber clips need on a crowded board?
Each lead is 24 inches long with a mini grabber at both ends, so you need room for the clip jaws and wire routing around dense components.
What is the first step when connecting the 3781-24 cords in the 5523 kit, and what mistake should be avoided?
Squeeze the grabber to open the hook, place it on the test point, then release; the common error is letting go before the hook seats fully on the pin or lead.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
