Polotrag PLG-0110 20 PSI 12000 mAh rechargeable pump
A rechargeable 20 PSI pump with 12000 mAh battery inflates a 10.5 ft board to 12 PSI in six minutes and deflates for easy packing
- MaterialNitrile
- Compatibility/FitmentPLG-0110, Polotrag
- Frequency Hznot_applicable
- Current TypeBattery Powered, battery
- Housing MaterialAcrylonitrile Butadiene Styrene
- Impeller MaterialAcrylonitrile Butadiene Styrene
- Inflates a 10.5 ft board to 12 PSI in 6 minutes
- Built-in 12000 mAh battery inflates up to four boards per charge
- Seven nozzles fit paddle boards, kayaks, tents, mattresses and more
- Weighs 2.98 lb and measures 10.6 x 7.6 x 3.5 inches with carry bag
- Digital LED screen shows real-time pressure in four units with four preset modes
Rechargeable SUP pump with auto-off
The Polotrag PLG-0110 is a battery-powered electric pump that inflates and deflates paddle boards, kayaks and air mattresses. Its built-in 12000 mAh pack removes the need for a mains outlet or car socket while on the water. A digital LED screen shows live pressure in four units and stops the motor automatically once the preset value is reached. The kit includes seven nozzles, a Type-C charging cable, an air hose and a carry bag.
Ideal for paddle-board owners needing cordless
Paddlers who want to reach 12 PSI on a 10.5 ft board in about six minutes without running an engine or dragging a cable will benefit. The same pump handles tents, yoga balls and pool inflatables through the supplied nozzles. Buyers who need continuous high-volume output for commercial rental fleets or who require pressures above 20 PSI should look at a different class of compressor.
20 PSI maximum pressure decides suitability
The pump tops out at 20 PSI, with a recommended operating target of 12 PSI for stand-up paddle boards and a 15 PSI upper guideline for that use. If your inflatable specifies a higher working pressure, this unit cannot meet it. For every board rated at or below that ceiling, the 12000 mAh battery delivers roughly four full inflations per charge.
Highlights
- Inflates a 10.5 ft board to 12 PSI in 6 minutes
- Built-in 12000 mAh battery inflates up to four boards per charge
- Seven nozzles fit paddle boards, kayaks, tents, mattresses and more
- Weighs 2.98 lb and measures 10.6 x 7.6 x 3.5 inches with carry bag
- Digital LED screen shows real-time pressure in four units with four preset modes
Specifications
| Material | Nitrile |
|---|---|
| Compatibility/Fitment | PLG-0110, Polotrag |
| Frequency Hz | not_applicable |
| Current Type | Battery Powered, battery |
| Housing Material | Acrylonitrile Butadiene Styrene |
| Impeller Material | Acrylonitrile Butadiene Styrene |
| Size/Dimensions | 13.6906 cm x 21.9964 cm x 30.988 cm |
| Commercial/Residential | pump, nozzles, Type-C cable, air hose |
| Parts | 1 Year |
| Labor | 1 Year |
| Brand | Polotrag |
| Model | PLG-0110 |
| Part Number | PLG-0110 |
Questions about this item
How often will the 12000 mAh battery need recharging when inflating 10.5 ft SUP boards to 12 PSI?
A full charge inflates four 10.5 ft boards to 12 PSI, so recharge after every fourth board or when the LED screen shows low power.
At what pressure does the auto-off stop the motor during sustained inflation?
The pump stops automatically once the preset pressure is reached, up to the 20 PSI maximum.
How hot or loud does the ABS housing get during a full day of back-to-back inflations?
The ABS housing stays cool to the touch and the motor runs quietly enough for normal outdoor use during continuous operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



