Pliobond
Pliobond PC-325-LV Contact Cement 25 Series Tan 1 qt Can
Tan contact cement bonds porous and non-porous surfaces with five-minute working time and heat resistance to 350°F
- TypeSealing Compound
- Strong bonds on porous and non-porous surfaces
- Heat resistant up to 350 Degrees F for demanding environments
- 5 minute working time speeds assembly tasks
- Brush or roll application suits varied workflows
- Water-resistant seal protects joints from moisture
Pliobond PC-325-LV Contact Cement 1 qt Can
Pliobond PC-325-LV is a contact cement formulated for bonding porous and non-porous surfaces. The tan adhesive comes in a one-quart can and is applied by brush or roller. It suits automotive, industrial and general repair tasks where a strong, heat-resistant bond is required. The product carries California Proposition 65 warnings for cancer and reproductive harm.
Thermals noise and power draw in normal use
The adhesive withstands continuous service up to 350 degrees F and short-term exposure up to 325 degrees F during application. It is flammable and emits a noticeable odour, so adequate ventilation is necessary. VOC content is 244 grams per litre and viscosity ranges from 400 to 1200 centipoise. Working time after application is approximately five minutes before surfaces must be joined.
Upgrades from solvent cements
This cement replaces general-purpose solvent adhesives that lack high-temperature resistance or water resistance. The jump is worth it when the assembly must survive sustained heat near 350 degrees F or repeated moisture exposure. Buyers needing a low-odour formula or a non-flammable adhesive will not find those properties here.
Highlights
- Strong bonds on porous and non-porous surfaces
- Heat resistant up to 350 Degrees F for demanding environments
- 5 minute working time speeds assembly tasks
- Brush or roll application suits varied workflows
- Water-resistant seal protects joints from moisture
Specifications
| Type | Sealing Compound |
|---|---|
| Brand | PLIOBOND |
Questions about this item
How do I apply the PC-325-LV contact cement and what step is often missed?
Apply a thin, even coat to both surfaces with a brush or roller, then wait until the adhesive is dry to the touch — about five minutes — before joining the parts.
Will the 1 qt can require any special storage or replacement over time?
Keep the can tightly sealed when not in use; the solvent-based formula will skin over or thicken if left open, eventually requiring a new can.
At what temperature does the bond start to degrade during sustained heat exposure?
The adhesive is rated for continuous service up to 350 °F; temperatures above that limit will cause the bond to soften and lose strength.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
