Planar
Planar PR9030 275W projector lamp DT00873
A ready-to-install 275 W replacement lamp module with 2,000 to 3,000 hour rated life for Planar PR9030 projectors
- TypeProjector Lamp
- Wattage275W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready-to-install lamp module with Ushio 275W bulb
- OEM replacement matching PR9030 DT00873 specifications
- 2000 normal or 3000 economy hours lamp life
- ISO 9001 quality checks on beam and ignition
- Fully assembled housing for immediate projector installation
Ready-to-install lamp module
The Planar PR9030 DT00873 is a new projector lamp that ships as a complete bulb-and-housing assembly. It is built for technicians and venue operators who need a direct swap without handling a bare bulb. A Ushio UHB 275W lamp provides the light source inside the module.
Replaces a dim or expired original
When the installed lamp reaches its rated hours or brightness drops below usable levels, this module restores the projector’s output. The step up is worthwhile when the existing lamp shows colour shift, flicker or a warning counter that cannot be reset. No other components are required for the changeover.
Rated for 2000 to 3000 hours
Normal mode delivers approximately 2000 hours of operation, while economy mode extends the span to roughly 3000 hours. The 275W rating sets the thermal and electrical load the projector must support. Venues running continuous daily cycles will reach the limit sooner than occasional-use installations.
Highlights
- Ready-to-install lamp module with Ushio 275W bulb
- OEM replacement matching PR9030 DT00873 specifications
- 2000 normal or 3000 economy hours lamp life
- ISO 9001 quality checks on beam and ignition
- Fully assembled housing for immediate projector installation
Specifications
| Brand | Planar |
|---|---|
| Type | Projector Lamp |
| Wattage | 275W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
Does the PR9030 lamp module include the housing so it fits directly into the projector?
Yes, the PR9030 module is a fully assembled 275W UHB bulb inside its housing, ready to seat in the projector without extra parts.
What is the correct order when installing the DT00873 lamp to avoid a loose connection?
Power off and cool the projector, remove the old module, align the new PR9030 connector firmly until it clicks, then replace the cover before restoring power.
How many hours can I expect from the 275W UHB bulb before replacement?
The lamp is rated for 2,000 hours in Normal mode or 3,000 hours in Economy mode before a new module is needed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



