PISKEKAT RG58 Coaxial RF Cable 49.2ft PL259 Male-Male 50 Ohm

RG58 50 Ohm Coaxial Cable for HF and VHF

This 49.2 ft RG58 coaxial cable uses a bare copper inner conductor with 50 ohm impedance for low-loss signal transmission. It terminates in PL259 male connectors at both ends for direct equipment hookup. The construction suits HF and VHF gear operating up to 300 MHz. Typical uses include CB radio, ham radio, SWR meters and antenna analysers.

Braided Shield and Foil Reduce Interference Over

A braided shield plus aluminium foil outer conductor wraps the PE insulation to block external noise across the full length. This shielding holds signal integrity when the cable runs near other wiring or inside a vehicle. The low-loss design keeps attenuation manageable for the 15 metre span at the stated frequency band.

Extended Heat Shrink Protects Connectors from Strain

Each PL259 plug receives a 6 cm heat shrink tube, longer than standard practice, to lock the joint against bending and pulling forces. The PVC sheath resists abrasion during routing through bulkheads or along masts. Connectors stay seated on antenna analysers, marine radios and base station gear despite vibration or frequent reconnection.