We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Coiled black RG58 coaxial cable with silver UHF PL259 male plugs and four silver adapters

PISKEKAT

PISKEKAT PC Game Controller 49.2Ft RG58 Coaxial Cable 50 Ohm UHF PL259 Male to Male with 4-Pack Adapters

SKU CH-2YEX-YDZ0W

A 49.2 ft RG58 coaxial cable with UHF PL259 male ends and four adapter types for ham and CB radio use

  • TypeOther
  • Corrosion-resistant adapters survive 48-hour salt-spray test
  • 6 cm heat-shrink strain relief stops connectors pulling off
  • 2 ft RG58 coax keeps signal loss low
  • Solid copper centre and braided shield protect integrity
  • Four adapters cover SMA male, SMA female, UHF SO239, BNC male

RG58 coaxial cable kit

The 49.2 ft RG58 coaxial cable uses solid copper with tinned copper braid, PE, aluminium foil and PVC jacket to keep signal loss low across 50 ohm runs. It terminates in UHF PL259 male connectors at both ends and ships with four SO239 female adapters for SMA male, SMA female, SO239 and BNC male interfaces. The kit suits CB radio, amateur radio, SWR meters and similar RF equipment.

Extended heat-shrink and salt-spray tested adapters

Each UHF male end is protected by a 6 cm heat-shrink tube that is professionally crimped to resist pull-out during bending or routing. The four included adapters passed a 48 hour salt-spray test, confirming corrosion resistance for longer service in outdoor or marine installations. Solid construction reduces the chance of intermittent connections when the cable is moved or vibrated.

Verify connector gender and impedance match

Before ordering, confirm that your radio or antenna presents a UHF female SO239 port for the PL259 male plugs, or that one of the four supplied adapters bridges to your device's SMA or BNC port. Ensure the system is designed for 50 ohm impedance, as the cable and connectors are specified for that value. The 49.2 ft length is fixed, so measure the required run between equipment and antenna mounting point.

Highlights

  • Corrosion-resistant adapters survive 48-hour salt-spray test
  • 6 cm heat-shrink strain relief stops connectors pulling off
  • 2 ft RG58 coax keeps signal loss low
  • Solid copper centre and braided shield protect integrity
  • Four adapters cover SMA male, SMA female, UHF SO239, BNC male

Specifications

TypeOther

Questions about this item

What signal loss can I expect from the 50 Ohm RG58 coax at 49.2 Ft?

The solid copper centre conductor, tinned copper braid, PE dielectric, aluminium foil and PVC jacket keep insertion loss low across HF and VHF bands used by CB, ham and marine radios.

What clearance do the 6 cm heat-shrink tubes and UHF PL259 plugs need behind the panel?

Each PL259 male connector has a 6 cm heat-shrink strain relief, so allow at least 7 cm depth behind the bulkhead for the plug body and shrink tube to seat without bending.

How do I attach the four SO239-to-SMA/BNC adapters without cross-threading the UHF threads?

Hand-tighten each adapter onto the cable's PL259 ends first, then use a 5/8 inch spanner for a final quarter turn; the 48 hour salt-spray tested plating resists galling.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.