We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A 25 foot RG58 coaxial cable with BNC male connectors on both ends

PISKEKAT

PISKEKAT 25ft 50 Ohm RG58 BNC Male to Male Coaxial Cable

SKU CH-MJ3C-W72JW

A 25 ft RG58 coaxial cable with BNC male connectors, 50 ohm impedance, 1.15 VSWR at 450 MHz, and 2.2 inch heat-shrink strain relief for RF and video signals

  • TypeOther
  • Low-loss signal over distance with pure copper and tinned braid shielding
  • Low VSWR of 1.15 at 450 MHz for clean, interference-free transmission
  • Solid copper centre conductor with bonded foil and tinned braid resists oxidation
  • 2 inch heat-shrink tube with inner adhesive prevents connector pull-out
  • 50 Ohm RG58 cable carries both RF and video for radio and scanner use

Cable type and intended use

This 25ft 50 Ohm RG58 coaxial cable carries RF and video signals between BNC male connectors. It suits amateur radio, scanner, two-way radio and antenna extension setups where a shielded, low-loss link is required.

Build integration and what it frees up

The 2.2 inch heat-shrink tubes with inner adhesive bond the connectors to the jacket, reducing pull-out risk during routing. Solid copper centre conductor, bonded aluminium foil and tinned copper braid resist oxidation, so the cable can stay in place without frequent re-termination.

Behaviour under sustained load

VSWR measures 1.15 at 450MHz, indicating consistent impedance match over the full length. Highly tinned copper braid and pure copper construction maintain shielding effectiveness and keep static and interference from accumulating during continuous transmission.

Highlights

  • Low-loss signal over distance with pure copper and tinned braid shielding
  • Low VSWR of 1.15 at 450 MHz for clean, interference-free transmission
  • Solid copper centre conductor with bonded foil and tinned braid resists oxidation
  • 2 inch heat-shrink tube with inner adhesive prevents connector pull-out
  • 50 Ohm RG58 cable carries both RF and video for radio and scanner use

Specifications

TypeOther

Questions about this item

How much signal loss should I expect over the 25 ft length at 450 MHz?

The cable has a VSWR of 1.15 at 450 MHz, indicating minimal reflection and low loss across the full 25 ft run.

Will the connectors stay tight and the jacket hold up if the cable runs warm all day?

Each BNC plug uses a 2.2 in heat-shrink tube with inner adhesive, and the braid is highly tinned copper to resist oxidation during continuous use.

What equipment do I need at each end to use this cable?

You need two devices with female BNC ports — such as radios, scanners, antennas or video gear — because both ends of the cable are BNC male plugs.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.