METRA 82-SU1 speaker adapter and wire harness kit 6.5-6.75 in car electronics accessory
- Speaker Spacers
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pioneer
6×9-inch two-way coaxial speakers deliver 95 W RMS and 460 W peak with a 29 Hz–49 kHz range, 92 dB sensitivity and 4-ohm impedance
Pioneer TSA693 6x9 two-way coaxial car speakers deliver 95 watts RMS and 460 watts peak power. The pair covers a frequency range of 29 Hz to 49,000 Hz with 92 dB sensitivity at 4 ohms impedance. Aramid fibre reinforced IMPP cones and 18 mm polyetherimide dome tweeters are built into a shallow basket design measuring 3.5 inches mounting depth. Grilles are included for protection.
These speakers fit standard 6x9 openings where mounting depth is limited to about 3.5 inches and 4 ohm impedance matches most head units or amplifiers. Buyers who need separate component sets for custom staging or who require lower impedance loads for specific amplifiers should consider other configurations. The coaxial design integrates tweeter and woofer in one frame, so it cannot be separated for aimed imaging.
The single specification that determines whether this pair will install without modification is the 3.5-inch mounting depth. Measure the available clearance behind your factory speaker location; if the space is less than this figure the speakers will not seat properly. All other performance figures remain theoretical until the physical fit is confirmed.
| Brand | Pioneer |
|---|---|
| Type | 2-way Speaker |
| Speaker Size | 6" x 9" |
| Features | 460 Watts Max power (95 Watts Nominal) |
| Model | TSA693 |
| Vehicle Type | ATV |
| Color | Black |
| Woofer Material | Polypropylene |
| Surround Material | Butyl rubber |
| Midrange | Coaxial |
| Voice Coil | dynamic_driver, Aramid fiber reinforced Injection Molded Polypropylene (IMPP) |
| Frame Construction | Aramid fiber reinforced Injection Molded Polypropylene (IMPP) |
| Part Number | TS-A693FH |
| Peak Power | 460 Watts |
| RMS Power | 60 Watts |
| Impedance | 4 Ohm |
| Mounting Depth | 3.5 inches |
The basket is 2-7/8 inches deep; the common error is assuming the 3.5-inch spec fits and skipping a spacer ring on doors with less clearance.
The butyl-rubber surround on the aramid-fiber IMPP woofer dries out over years; listen for edge buzz at 95 watts RMS that signals it is time to swap the pair.
The 18 mm PEI tweeter with its 0.17 oz neodymium magnet reaches its thermal ceiling before the 11.39 oz ferrite woofer, so sustained peaks above 95 watts RMS risk tweeter compression.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?