We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pigtronix Space Rip synth pedal with five knobs and toggle switch

Pigtronix

Pigtronix Space Rip PWM Synth Guitar Pedal

SKU CH-XVT0-2RQ1P

An analog synth pedal with PWM sawtooth and square waves, a tracking engine for fast single-note lines, and Sub and Octave controls for deep bass tones

  • Analog synth voices with PWM sawtooth and square waves
  • Fast tracking engine replicates pitch and dynamics of single-note lines
  • Sub knob adds voice one octave down from input
  • Octave switch drops entire synth sound down an additional octave
  • Runs on standard 9VDC power supply

Analog PWM Synth Pedal

The Pigtronix Space Rip is an analog synth pedal that generates pulse-width-modulated sawtooth and square waves in multiple octaves. A tracking engine follows fast single-note lines while preserving pitch and dynamics. The Rate knob drives an onboard LFO that constantly reshapes both oscillators for thick, evolving textures. It runs on a standard 9 V DC supply.

Simple Pedalboard Integration

Connect the pedal to a regular 9 V DC power source and patch it into your signal chain like any other effect. No firmware updates or computer editors are required; all parameters are set with the front-panel knobs and switch. The only common issue is accidental battery drain if a DC jack is left plugged in while the unit sits unused.

Mono Instrument-Level Operation

The pedal accepts a mono instrument-level signal and outputs a mono synth voice, so it cannot process stereo sources or line-level signals without external adaptation. Tracking is designed for single notes; chords or complex intervals will not be rendered cleanly. The fixed 9 V DC requirement also means it cannot run directly from higher-voltage or AC supplies.

Highlights

  • Analog synth voices with PWM sawtooth and square waves
  • Fast tracking engine replicates pitch and dynamics of single-note lines
  • Sub knob adds voice one octave down from input
  • Octave switch drops entire synth sound down an additional octave
  • Runs on standard 9VDC power supply

Specifications

No published specifications for this item yet.

Questions about this item

How can I verify the Pigtronix Space Rip is tracking my playing correctly after setup?

Play fast single-note lines and listen for the pedal replicating both pitch and dynamics accurately; the onboard VCO should keep the pulse width in constant flux, creating harmonic motion controlled by the Rate knob.

What comes in the box with the Pigtronix Space Rip and what must I supply?

The pedal itself is included; you must provide a standard 9 V DC power supply as it runs on 9 VDC.

Which octave setting should I choose on the Space Rip for deep analog synth bass?

Engage the Octave switch to drop the entire synth sound down an additional octave, and use the Sub knob to add a voice one octave below the input signal for maximum low-end weight.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.