We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

PigHog Cables

PigHog Cables PCH10CAR 1/4" 10 ft Right Angle Cable

SKU CH-QNM9-J30FQ

A 10 ft right-angle instrument cable with 1/4" plugs on both ends, made in the United States

  • 10 ft length gives room to move on stage
  • Right-angle plug fits tight pedalboard jacks
  • 1/4″ connectors work with standard instrument gear
  • Made in the United States for consistent build quality
  • New condition means full factory performance

What this cable does

The PigHog PCH10CAR is a 10 ft instrument cable fitted with a right-angle 1/4" plug at each end. Musicians and stage technicians use it to connect guitars, keyboards or pedals where a straight plug would protrude too far. It is built in the United States and ships new.

Everyday handling

The right-angle plugs reduce strain on jack sockets when gear is packed tightly on a pedalboard or amp top. Ten feet of cable gives enough reach for most stage positions without leaving large coils on the floor. The construction is intended for regular rehearsal and gig use.

Right-angle requirement

This cable only works where both the source and destination jacks accept a right-angle 1/4" connector. If either piece of equipment needs a straight plug — such as some recessed inputs or crowded rack panels — this model will not fit.

Highlights

  • 10 ft length gives room to move on stage
  • Right-angle plug fits tight pedalboard jacks
  • 1/4″ connectors work with standard instrument gear
  • Made in the United States for consistent build quality
  • New condition means full factory performance

Specifications

No published specifications for this item yet.

Questions about this item

How do I plug in the right-angle plug on the 10 ft cable without bending the jack?

Insert the right-angle plug straight into the 1/4" jack until it seats fully; avoid twisting the housing sideways, which stresses the solder joints inside the connector.

When will the 10 ft instrument cable need replacement?

Replace the cable if the shielding braid becomes exposed, the conductors show corrosion, or intermittent signal appears when the cable is flexed near either 1/4" plug.

What is the first sign of signal loss during a long set with this 10 ft cable?

High-frequency roll-off appears first as capacitance builds over the 10 ft run, making the tone sound dull before the signal drops out completely.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.