We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 30cm PWM fan cable with male 4-pin connectors both ends

Phobya

Phobya 4-Pin PWM Male-to-Male 30cm Fan Cable Adapter (1012290) Black

SKU CH-RAJV-P4FPY

A 30 cm black PWM fan cable with male connectors on each end for DIY cable management and fan controllers

  • ColorBlack
  • 30 cm length gives flexible routing inside cases
  • 4-pin PWM connectors carry speed control signals
  • Male-to-male design links fan directly to controller
  • Black sheath keeps build aesthetics consistent
  • Supports DIY cable management for tidy airflow

PWM fan extension cable

The Phobya 4-pin PWM male-to-male adapter extends a fan connection by 30 centimetres. It carries both power and speed-control signals between a fan and a motherboard header or fan controller. The black sleeving matches typical case interiors. Builders who need a longer PWM link for tidy routing will find it useful.

Suits custom loops and tight routing.

The cable works with any standard 4-pin PWM fan or controller that follows the common pinout. It helps when the stock lead falls short in large chassis or behind radiator stacks. Buyers whose fans use 3-pin voltage control cannot use PWM regulation through this adapter. Systems that require a female socket on one end should choose a different cable.

Male-to-male ends enable direct fan-to-header links

Each end terminates in a 4-pin PWM male plug so the cable bridges two female ports without extra couplers. This simplifies cable management in custom water-cooling loops and fan-wall builds. No software, splitters or additional connectors are bundled with the adapter.

Highlights

  • 30 cm length gives flexible routing inside cases
  • 4-pin PWM connectors carry speed control signals
  • Male-to-male design links fan directly to controller
  • Black sheath keeps build aesthetics consistent
  • Supports DIY cable management for tidy airflow

Specifications

ColorBlack

Questions about this item

What fan header type must my motherboard or controller provide for the Phobya 4-pin PWM male-to-male adapter to work?

The adapter uses a standard 4-pin PWM connector, so the header on your motherboard or fan controller must also be a 4-pin PWM header.

Can I keep using my existing 3-pin voltage-controlled fans with this 4-pin PWM male-to-male cable?

The cable carries a PWM signal on the fourth pin; a 3-pin fan will run but cannot receive PWM control, so speed regulation will fall back to voltage mode if the header supports it.

How can I confirm the Phobya 30 cm PWM cable is delivering a PWM signal after I connect it?

In BIOS or fan-control software, set a custom curve; the attached fan should follow the curve instead of staying at a fixed speed.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.