We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black sleeved Y-cable with 4-pin PWM, 4-pin PWM and 4-pin Molex connectors, 50cm long

Phobya

Phobya 1012263 Y-Cable 4-Pin PWM to 4-Pin PWM & 4-Pin Molex 50cm

SKU CH-GDR0-MK80W MPN 1012263

A PWM Y-splitter powers two fans from one motherboard header while drawing extra current through a Molex connector, 50 cm long with black sleeving and heatshrink

  • ColorBlack
  • FeaturesSince the controlling fans via the Mainboard with PWM is muc
  • Splits one PWM header to drive two fans
  • Molex power tap offloads current from the motherboard
  • 50 cm length fits most mid-tower routing paths
  • Black sleeving and heatshrink protect against abrasion
  • All-black connectors keep the build visually consistent

PWM Fan Splitter for Motherboard Control

This Phobya Y-cable lets two 4-pin PWM fans run from a single motherboard header while drawing power through a 4-pin Molex connector. It suits builders who want PWM speed control without buying a dedicated fan controller.

Sustained Operation with Sleeved Protection

The 50 cm length is fully covered in black Flexsleeves that guard against abrasion during continuous use. Heat-shrink tubing at each connector end keeps the termination tidy and reduces strain on the wires over long periods.

Simple Installation with One Limitation

Plug the 4-pin PWM lead into the motherboard header, connect two PWM fans to the splitter ends, and attach the Molex plug to the power supply. The cable cannot supply PWM control to fans that lack a 4-pin PWM input.

Highlights

  • Splits one PWM header to drive two fans
  • Molex power tap offloads current from the motherboard
  • 50 cm length fits most mid-tower routing paths
  • Black sleeving and heatshrink protect against abrasion
  • All-black connectors keep the build visually consistent

Specifications

BrandPhobya
Model1012263
ColorBlack
FeaturesSince the controlling fans via the Mainboard with PWM is much cheaper than using a fan controller, this cable is to solve that issue.

Questions about this item

Does the 50 cm Phobya 1012263 Y-cable add any heat or noise when running fans continuously?

The cable itself is passive wiring with sleeved conductors and heat-shrink ends, so it does not generate heat or audible noise; only the connected fans produce sound and warmth.

What motherboard header and power supply connector are required to use the Phobya 1012263 splitter?

You need one free 4-pin PWM fan header on the motherboard and one spare 4-pin Molex connector from the power supply to feed the two attached fans.

Will the Phobya 1012263 splitter work with older 3-pin fans I already own?

The splitter provides two 4-pin PWM outputs; 3-pin fans will fit mechanically but will run at fixed voltage without PWM speed control from the motherboard header.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.