We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Philips Sim2 Domino D80E DLP replacement lamp bulb only

Philips

Philips Sim2 Domino D80E DLP Replacement Lamp 200-150W 1.0 P22

SKU CH-H71D-MWFE7

A replacement lamp for the Sim2 Domino D80E projector using a 200-150W 1.0 P22 bulb

  • TypeProject Lamp
  • Weight0.9900
  • OEM Philips bulb ensures exact optical match for Sim2 Domino D80E
  • 200-150W 1.0 P22 lamp spec matches original projector requirements
  • 180-day warranty period covers early-life failures
  • Bulb-only design reduces replacement cost versus full module
  • 99 kg weight confirms standard DLP lamp form factor

Compatible projector model

This replacement lamp is built for the Sim2 Domino D80E projector. It contains a Philips bulb inside a Jaspertronics OEM module rated at 200-150W with a 1.0 P22 designation. The unit is supplied new and weighs 0.9900 kg. It is intended for owners who need a direct bulb-only swap without changing the housing.

Sustained brightness stability

The lamp operates across a 200-150W power range to maintain consistent output during long viewing sessions. Philips DLP technology is designed to resist rapid lumen decay so image quality holds steady over hours of continuous use. The 180 day warranty period reflects the expected reliability window under normal operating conditions.

Bulb-only installation notes

Installing a bare bulb requires careful handling of the quartz envelope to avoid contamination that shortens life. The module fits the existing D80E cage but alignment pins must seat fully or the projector will not strike. Users often forget to reset the lamp timer after replacement which triggers a false end-of-life warning.

Not for multi-lamp arrays

This single bulb module cannot support projectors that require dual-lamp configurations or higher wattage chambers. Buyers needing redundancy or brighter output for large venues should look elsewhere.

Highlights

  • OEM Philips bulb ensures exact optical match for Sim2 Domino D80E
  • 200-150W 1.0 P22 lamp spec matches original projector requirements
  • 180-day warranty period covers early-life failures
  • Bulb-only design reduces replacement cost versus full module
  • 99 kg weight confirms standard DLP lamp form factor

Specifications

BrandJaspertronics
ModelSim2-Domino-D80E-Bulb
Part NumberSim2-Domino-D80E-Bulb
TypeProject Lamp
Weight0.9900

Questions about this item

How much power does the 200-150W 1.0 P22 lamp draw when the projector runs all day?

The lamp operates within a 200-150W range, so power draw will vary between those two figures depending on the projector's brightness mode.

Does the bulb-only unit require a separate housing or cage that I must already own?

Yes, this is a bulb-only module; you must reuse the existing lamp housing from your Sim2 Domino D80E projector.

Will this 1.0 P22 lamp work in the older Sim2 Domino D80E without any firmware update?

It is designed as a direct replacement for the Sim2 Domino D80E, so no firmware change is needed for compatibility.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.