We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Perle SR-1110-ST10 media converter DIN rail mount

Perle

Perle SR-1110-ST10 Media Converter Mount

SKU CH-YARS-EH8AY

Mounts a 10/100/1000 media converter with ST single-mode fibre up to 6.2 miles on DIN rail

  • TypeData & Communication
  • SizeMaximum frame size of 10,240 bytes
  • Converts copper to single-mode fibre up to 10 km
  • Supports 10/100/1000 Mbps speeds for flexible networks
  • Maximum frame size of 10,240 bytes handles large packets
  • DIN rail mounting suits industrial cabinet installations
  • Terminal block power connector enables external DC supply

Industrial Gigabit Media Converter

The Perle SR-1110-ST10 converts 10/100/1000BASE-T copper signals to 1000BASE-LX/LH single-mode fibre. It supports a maximum frame size of 10,240 bytes and reaches 10 km at 1310 nm. The DIN-rail enclosure fits industrial cabinets and uses a terminal-block power connector for external supply.

Replacing shorter copper runs

This unit replaces copper links that exceed 100 m or 328 ft where signal loss or noise becomes an issue. The jump is worth it when you need to bridge buildings or extend a network across a plant floor without repeaters. It also solves ground-loop problems between separate power domains.

Check power and fibre before ordering

Verify you have a suitable external power source for the Combicon terminal block. Confirm the far-end equipment uses 1000BASE-LX/LH optics at 1310 nm with ST connectors. Ensure single-mode fibre patch cords and patch panels are available for the 10 km link.

Highlights

  • Converts copper to single-mode fibre up to 10 km
  • Supports 10/100/1000 Mbps speeds for flexible networks
  • Maximum frame size of 10,240 bytes handles large packets
  • DIN rail mounting suits industrial cabinet installations
  • Terminal block power connector enables external DC supply

Specifications

BrandPERLE SYSTEMS
TypeData & Communication
SizeMaximum frame size of 10,240 bytes

Questions about this item

Does the SR-1110-ST10 mount on a standard DIN rail?

The unit is housed in a DIN rail case that snaps onto standard DIN rails inside an industrial cabinet.

How is power connected to the SR-1110-ST10?

Power is supplied through a Combicon terminal block on the case; wire the external source to the block using the correct polarity.

Does the ST fibre connector on the SR-1110-ST10 need periodic cleaning?

Yes, the ST connector should be inspected and cleaned with a lint-free wipe and approved solvent whenever signal loss is suspected.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.