We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Olive drab green roto-moulded polyethylene trunk with single hinged lid, steel latches and recessed hardware

Pelican Products, Inc.

Pelican AL3620-1710 Single Hinged Lid Trunk without Foam Olive Drab Green camera case

SKU CH-0Z4J-AWTZ2

A watertight, roto-moulded equipment trunk offering 11.25 cubic feet of empty interior space and operating from -29 to 60 °C

  • Roto-molded polyethylene body withstands heavy impact
  • Steel nickel-black plated latches secure the lid tightly
  • Silicone sponge O-ring seals out water and dust
  • Operates reliably from -29 °C to 60 °C
  • 25 cubic feet interior fits extensive camera gear

Pelican AL3620-1710 Trunk for Professional Gear

The Pelican AL3620-1710 is a roto-moulded polyethylene trunk built to protect cameras and sensitive equipment during transport. Its single hinged lid and olive drab green finish suit field photographers, videographers and crews who need a watertight, crush-resistant container that can be stacked securely on location.

Reinforced Hardware and Stacking Ribs

Nickel-black plated steel latches and stainless steel pins keep the lid sealed after heavy impacts. Molded-in metal inserts spread latch loads across the body, while integrated ribs and corrugations prevent cases from sliding when stacked in vehicles or storage. A silicone sponge O-ring and tongue-in-groove parting lines maintain splash resistance without added foam inserts.

Verify Interior Volume and Temperature Limits

The interior provides 11.25 cubic feet of configurable space, so confirm your kit fits before ordering. The case is rated from -29 to 60 degrees Celsius, which covers most outdoor environments but may not suit extreme cold-chain or desert operations. No foam is included, so plan for custom inserts or padded dividers.

Highlights

  • Roto-molded polyethylene body withstands heavy impact
  • Steel nickel-black plated latches secure the lid tightly
  • Silicone sponge O-ring seals out water and dust
  • Operates reliably from -29 °C to 60 °C
  • 25 cubic feet interior fits extensive camera gear

Specifications

No published specifications for this item yet.

Questions about this item

How often should the silicone sponge O-ring be inspected or replaced to keep the case watertight?

Inspect the O-ring before each use for cuts or compression set; replace it if it no longer springs back or shows visible damage, as the seal depends on its integrity.

At what temperature does the roto-moulded polyethylene body approach its rated limit during extended outdoor exposure?

The case is rated from -29 °C to 60 °C; sustained temperatures near 60 °C may soften the polyethylene and reduce impact strength.

Does the purge body valve release enough pressure to stop the lid from becoming hard to open after a day in the sun?

The aluminium purge valve equalises pressure caused by temperature swings up to 60 °C, preventing vacuum lock that would make the steel latches difficult to release.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.