Peakworks
Peakworks V8561801 Pest Contol 1-1/16" x 1-1/4" Press Block HDPE
A reusable HDPE press block secures large round or hex-shank tools to prevent drops through 19-4 grating
- Size1-1/16 In. x 1-1/4 In.
- Green HDPE construction for visible identification on site
- Fits 1-1/16" x 1-1/4" tool shanks for secure tethering
- Reusable clamp design allows repositioning without waste
- Tested to CSA standards for fall-prevention confidence
- Blocks tools from falling through 19-4 grating openings
Press Block for Tool Tethering
The Peakworks V8561801 press block is a component of a tool tethering system built for workers at height. It fits large round and hex shank tool bodies and is intended to prevent tools from falling through 19 construction site grating.
Durable HDPE Construction
Made from HDPE with a rubber insert, the clamp operates in extreme cold and high heat while maintaining a secure grip. It has been subjected to rigorous CSA laboratory testing to verify its clamping strength and long-term durability.
Reusable Clamp with Rubber Insert
Unlike heat-tape anchoring, this clamp can be reused and repositioned as needed. The additional rubber insert expands sizing options and increases clamping grip. Each unit ships in an individual blister pack and carries California Proposition 65 warnings for cancer and reproductive harm.
Highlights
- Green HDPE construction for visible identification on site
- Fits 1-1/16" x 1-1/4" tool shanks for secure tethering
- Reusable clamp design allows repositioning without waste
- Tested to CSA standards for fall-prevention confidence
- Blocks tools from falling through 19-4 grating openings
Specifications
| Brand | PEAKWORKS |
|---|---|
| Size | 1-1/16 In. x 1-1/4 In. |
Questions about this item
How do I install the press block on a large round or hex shank tool, and what step is often missed?
Slide the block over the tool shank, insert the rubber sleeve for a tighter grip, then tighten the clamp; the step often missed is adding the rubber insert before securing the clamp.
What part will need replacement first with repeated use?
The rubber insert wears faster than the HDPE block and should be replaced when it no longer fills the gap or provides firm clamping pressure.
What limits safe use on 19 mm grating during prolonged overhead work?
The clamp is tested to prevent tools from falling through 19 mm grating, but sustained vibration can loosen the fastener, so re-check torque regularly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
